Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Machine Design
In second type of levers,
load is in between the fulcrum and effort
effort is in between the fulcrum and load
fulcrum is in between the load and effort
none of these
Correct Answer:
load is in between the fulcrum and effort
← Previous Question
Next Question→
More Questions from
Machine Design
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)
A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where σ = Stress for a plate with no hole i.e. nominal stress)
The velocity of sliding __________ the distance of the point of contact from the pitch point.
The square threads are not so strong as V-threads but they offer less frictional resistance to motion than Whitworth threads.
The pipe joint mostly used for pipes carrying water at low pressures is
A column is known as a long column if the slenderness ratio is
The resistance to fatigue of a material is measured by
The value of stress concentration factor depends upon
For unequal width of butt straps, the thickness of butt straps are
According to I.B.R., shearing resistance required to shear off the rivet per pitch length (in double shear) is (where n = Number of rivets per pitch length)
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments