Curioustab

Home » Digital Electronics » Digital System Projects Using HDL

The full-step sequence always has two coils of the stepper motor energized in any state of the sequence and typically causes 30° of shaft rotation per step.

True
False

Correct Answer: False

← Previous Question Next Question→

More Questions from Digital System Projects Using HDL

In the digital clock project, the AHDL block codes are connected using graphic design files.
One of the first steps in any HDL project is to define its scope by knowing the nature of all the signals that are interconnected to pieces of the project.
In the keypad HDL encoder, the data signal is used to combine the row and column encoder data to make a 4-bit value representing the key that was pressed.
In the VHDL code of the stepper motor, the cout outputs are bit_vector type because they are binary bit patterns.
In HDL, one of the strategies used in strategic planning is to find the speed requirements.
In the digital clock project, frequency prescaling is used to take a 1 pps input and transform it into a 60 pps timing signal.
The direct drive mode of a stepper motor allows for less control by the operator.
In the keypad HDL encoder, the freeze bit detects when a key is released.
The half-step sequence of a stepper motor is created by inserting a start with only one coil energized between full steps.
In the keypad encoder, the ________ detects when a key is pressed.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion