Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics
»
Operational Amplifiers
Op-amps used as high- and low-pass filter circuits employ which configuration?
noninverting
comparator
open-loop
inverting
Correct Answer:
inverting
← Previous Question
Next Question→
More Questions from
Operational Amplifiers
An inverting amplifier has a phase shift of 180° from input to output.
If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity to the input.
If the two inputs to a differential amplifier are exactly the same, then the output is the signal multiplied by 2.
The ideal output impedance for an operational amplifier is 0 Ω.
Crystal oscillator circuits have a very low Q.
Feedback is used in an open-loop operational amplifier circuit.
An astable multivibrator has two states.
The feedback resistor adds to the gain of an op-amp.
It takes 4 µs for the output voltage of an op-amp to rise from –14 V to +14 V. The slew rate of this op-amp is 3.5 V/µs.
In a common-mode input to an op-amp, both inputs are connected to the same signal source.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments