Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics
»
Measurement, Conversion and Control
The resistive change of a strain gauge
is based on the weight placed upon it, but can be many thousands of ohms
is usually no more than 100 Ω
is based on the gauge factor, but is typically less than an ohm
has a positive temperature coefficient
Correct Answer:
is based on the gauge factor, but is typically less than an ohm
Next Question→
More Questions from
Measurement, Conversion and Control
The change in value of an analog signal during the conversion process produces what is called the
The purpose of compensation for a thermocouple is
What is the moving part of a linear variable differential transformer?
Holding current for an SCR is best described as
What device is similar to an RTD but has a negative temperature coefficient?
Which of the following performance specifications applies to a sample-and-hold circuit?
What is the zero-voltage switch used for?
RTDs are typically connected with other fixed resistors
The silicon-controlled rectifier can be turned off
The output voltage of a typical thermocouple is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments