Curioustab

Home » Electronics and Communication Engineering » Radio Receivers

The sensitivity of a superheterodyne receiver is determined by

the gain IF amplifier
the gain of RF amplifier
the noise figure
all of the above

Correct Answer: all of the above

← Previous Question Next Question→

More Questions from Radio Receivers

In a superheterodyne receiver, the IF stage has better selectivity than RF stage because
An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The efficiency of detection is
The problem associated with tuned-radio frequency receiver is
In a radio receiver
Which of the following produces upper and lower side frequencies?
In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 1000 kHz will be
A receiver having poor IF selectivity will also have poor
The typical squelch circuit
Most of the amplification of the received signal is obtained in a superheterodyne receiver from the
The household radio receiver uses

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion