Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics and Communication Engineering
»
Microwave Communication
Assertion (A): In TE mode for rectangular waveguide. Reason (R): In TM mode for rectangular waveguide.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
Correct Answer:
Both A and R are correct but R is not correct explanation of A
← Previous Question
Next Question→
More Questions from
Microwave Communication
The secondary constants of a line are
To ensure that only dominant TE10 mode propagates in a rectangular waveguide, the operating frequency
Z0 = (Zoc Zsc)0.5
Characteristic impedance of a coaxial cable is inversely proportional to ∈r.
The following components are used to measure power output of a 2 kW TWT amplifier TWT Low pass/High pass filter Low power 20 dB attenuator 40 dB directional coupler with matched load Power meter. The correct sequence of connections of these components is:
Hollow waveguides are used as transmission lines at frequencies
A rectangular wave guide has two stubs each of length connected at the source end. The stubs are circuited. Then the stubs present
A 3 port circulator is in the given figure. Its scattering matrix is
Integrated fin line can be utilized as a medium for constructing millimeter wave circuits.
A line of length slightly longer than and open circuited at far end behaves as
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments