Curioustab

Home » Electronics and Communication Engineering » Measurements and Instrumentation

A digital frequency counter can be converted to DVM by addition of a suitable

voltage controlled oscillator
D/A converter
power amplifier
operational amplifier

Correct Answer: D/A converter

Explanation:

D/A converter changes digital output to analog output.

← Previous Question Next Question→

More Questions from Measurements and Instrumentation

Assertion (A): When a wattmeter is used for low impedance loads, the pressure coil is connected across the load. Reason (R): A wattmeter measures apparent power.
In which of the transformer is the secondary nearly short circuited under normal operating conditions?
A single phase energy meter has the rating 1200 resolutions/ kWh. If a 500 W electric gadget is used for 4 hours, the energy meter will make
If reference sound pressure P0 is 2 x 10-5 N/m2, a sound pressure of 90 dB is equal to
Assertion (A): A hot wire ammeter has a cramped scale. Reason (R): The heat is proportional to square of current.
Consider the following statements: In a differential amplifier using JFET, the differential output offset is due to mismatch between FET parameters difference in values of resistances used in circuit variation in supply voltage. Of the statements, the correct statements are
A full wave rectifier type meter is used to measure the wave shape shown in figure. The voltmeter is calibrated to read rms value of sine wave. The reading of voltmeter will be
A moving iron instrument gives correct reading when used at
Loss of charge method is suitable for medium resistances.
Which of the following is true about an impulse voltage?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion