Home » Electronics and Communication Engineering » Matching Questions

Match the following: List I List II A. AM-DSB FC 1. 2 B. WBFM 2. 1 C. PCM 3. 3m D. AM-DSB 4. 22N

A-1, B-2, C-3, D-4
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1
A-4, B-3, C-2, D-1

Correct Answer: A-2, B-3, C-4, D-1

← Previous Question Next Question→

More Questions from Matching Questions

List I (Parameters) List II (Values) A. h22 1. rb + re B. h11 2. acb C. h21 3.
Match the following: List I List II A. IF noise 1. Ganged tuning B. Image frequency 2. Spurious response C. Station selector 3. Leaky filter capacitor D. Excessive Hum 4. Mixer stage
Match the following: List I (Diode circuit) List II (Name of the circuit) A. 1. Positive limiter B. 2. Positive clamper C. 3. Negative clamper
Match the following: List I (Modes) List II (Characteristic) A. Evanescent 1. Rectangular waveguide does not support B. Dominant mode 2. No wave propagation C. TM10 and TM01 3. Lowest cut-off frequency
Match the following: List I List II A. D Layer 1. 110 km B. E layer 2. 10 km C. F layer 3. 60 km D. Troposphere 4. 350 km
Match the following: List I List II A. loop antenna 1. flat line B. folded dipole 2. 300 W C. SWR of 1 3. sharp broadside full D. VHF band 4. 30 to 300 MHz
Match the following: List I (Devices) List II (characteristic) A. BJT 1. Voltage controlled negative resistance B. MOSFET 2. High current gain C. Tunnel diode 3. Voltage regulation D. Zener diode 4. High input impedance
Match the following: List I (Logic) List II (Characteristic) A. RTL 1. High fan out B. CMOS 2. Highest speed of operation C. I2L 3. High noise immunity D. ECL 4. Lowest product of power and delay
Match the following: List I List II A. Effective length of antenna 1. B. Capture area 2. C. Front to back ratio 3.
Match the following: List I List II A. FM 1. slope-overload B. DM 2. μ law C. PSK 3. Envelope detector D. PCM 4. Capture effect 5. Hilbert transform 6. Matched filter.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion