Curioustab

Home » Electrical Engineering » RL Circuits

When the frequency of the voltage applied to a series RL circuit is decreased, the impedance

decreases
increases
does not change
cannot be determined without values

Correct Answer: decreases

← Previous Question Next Question→

More Questions from RL Circuits

A 47 Ω resistor is in series with an inductive reactance of 120 Ω across an ac source. The impedance, expressed in polar form, is
A 3.3 kΩ resistor and a 120 mH coil are in parallel. Both components are across a 2 kHz, 12 V ac source. The total current in the circuit is
A 1.2 kΩ resistor is in series with a 15 mH coil across a 10 kHz ac source. The magnitude of the total impedance is
When the frequency of the voltage applied to a series RL circuit is increased, the phase angle
A 470 Ω resistor and a 200 mH coil are in parallel. Both components are across a 1.5 kHz ac source. The total admittance of the circuit, in polar form, is
A 470 Ω resistor and a coil with 125 Ω inductive reactance are in parallel. Both components are across a 15 V ac voltage source. Current through the inductor is
In a series RL circuit, 12 V rms is measured across the resistor, and 14 V rms is measured across the inductor. The peak value of the source voltage is
When the resistor voltage in a series RL circuit becomes less than the inductor voltage, the phase angle
The phase angle (θ) of a series RL circuit varies directly with frequency.
A power factor of 1 indicates a purely reactive circuit, and a power factor of 0 indicates a purely resistive circuit.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion