Curioustab

Home » Electrical Engineering » Passive Filters

The same signal in Problem 2 is applied to an RC high-pass filter. If the reactance is zero at the input frequency, the output voltage is

18 V peak-to-peak
zero
9 V peak-to-peak
12.73 V peak-to-peak

Correct Answer: 18 V peak-to-peak

← Previous Question Next Question→

More Questions from Passive Filters

In a series resonant band-pass filter, a lower value of Q results in
The maximum output voltage of a certain low-pass filter is 15 V. The output voltage at the critical frequency is
An RC low-pass filter consists of a 120 Ω resistor and a 0.002 µF capacitor. The output is taken across the capacitor. The circuit's critical frequency is
Referring to Problem 15, if the input voltage is a 6 V sine wave with a dc level of 10 V, what is the output voltage magnitude?
In a certain parallel resonant band-pass filter, the resonant frequency is 14 kHz. If the bandwidth is 4 kHz, the lower frequency
An RC high-pass filter consists of a 0.2 µF capacitor and a 220 Ω resistor. The output is taken across the resistor. The circuit's critical frequency is
Referring to Problem 23, what will the output voltage be if the coil's internal resistance is neglected?
A series resonant band-pass filter consists of a 2 mH coil, a 0.005 µF capacitor, and a 120 Ω resistor. The winding resistance of the coil is 12 Ω. The output voltage is taken off the resistor. Input voltage is 12 Vrms. What is the output voltage magnitude at the center frequency (f0)?
A series resonant band-stop filter consists of a 68 Ω resistor, a 110 mH coil, and a 0.02 µF capacitor. The internal resistance, RW, of the coil is 4 Ω. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?
In a certain low-pass filter, fc = 3.5 kHz. Its passband is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion