Discussion
Home ‣ Digital Electronics ‣ Digital System Projects Using HDL Comments
- Question
The step rate of the simulation of a stepper motor is probably ________ the actual stepper motor.
Options- A. slower than
- B. more than
- C. almost the same as
- D. exactly the same as
- Correct Answer
- slower than
- 1. One of the first steps in small-project management is to determine ________.
Options- A. how many devices are controlled by the outputs
- B. a way to test each block
- C. if each block fits together
- D. how each block works Discuss
- 2. VARIABLES are considered to be updated ________ within a sequence of statements in a PROCESS, whereas SIGNALS referred to in a PROCESS are updated when the PROCESS ________.
Options- A. once, starts
- B. immediately, suspends
- C. twice, ends
- D. never, starts Discuss
- 3. In the stepper motor, the half-step sequence is used when ________.
Options- A. less torque is needed
- B. larger steps are desired
- C. smaller steps are desirable
- D. more torque is needed Discuss
- 4. In the digital clock project, when it is 11:59:59, AND gate 1 detects that the tens of hours is 1 and the enable input is active. On the next clock pulse the AM/PM flip-flop will ________.
Options- A. set
- B. reset
- C. toggle
- D. clear Discuss
- 5. In the digital clock project HDL code, the MOD-12 counter is using ________.
Options- A. a BCD counter followed by a MOD-2 counter
- B. a single HDL module
- C. a MOD-6 counter followed by a MOD-2 counter
- D. a MOD-12 counter followed by a D flip-flop Discuss
- 6. In the keypad encoder, the ring counter is implemented using ________ that responds to the clk input.
Options- A. SIGNAL
- B. FUNCTION
- C. CASE
- D. PROCESS Discuss
- 7. The timing and control block provides the ________ for the frequency counter.
Options- A. brains
- B. BCD counters
- C. display register
- D. six different frequency measurement ranges Discuss
- 8. Using one case construct inside another is known as ________.
Options- A. doping
- B. functioning
- C. freezing
- D. nesting Discuss
- 9. In the digital clock project, the 60 Hz signal is sent through a Schmitt-trigger circuit to produce square pulses at the rate of ________.
Options- A. 1 pps
- B. 60 pps
- C. 100 pps
- D. 600 pps Discuss
- 10. In the keypad encoder, the ________ activate(s) the freeze bit only when one column is low.
Options- A. NAND columns
- B. CASE structure
- C. freeze function
- D. BCD counter Discuss
Digital System Projects Using HDL problems
Search Results
Correct Answer: how many devices are controlled by the outputs
Correct Answer: immediately, suspends
Correct Answer: smaller steps are desirable
Correct Answer: toggle
Correct Answer: a single HDL module
Correct Answer: PROCESS
Correct Answer: brains
Correct Answer: nesting
Correct Answer: 60 pps
Correct Answer: CASE structure
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.