Discussion
Home ‣ Digital Electronics ‣ Integrated-Circuit Logic Families Comments
- Question
The output stage of a TTL gate is a special design called ________.
Options- A. multiemitter
- B. totem-pole
- C. MSI
- D. DIP
- Correct Answer
- totem-pole
- 1. ________ output levels would not be a valid LOW for a TTL gate.
Options- A. 0.2 V
- B. 0.3 V
- C. 0.5 V
- D. All of the above. Discuss
- 2. Several manufacturers have developed logic that combines the best features of TTL and CMOS. This is called ________.
Options- A. 12L
- B. BiCMOS
- C. 74ACT
- D. 74HCT Discuss
- 3. The lower transistor of a totem-pole output is saturated when the gate output is ________.
Options- A. overdriven
- B. HIGH
- C. LOW
- D. malfunctioning Discuss
- 4. A logic probe is placed on the input of a digital circuit and the probe lamp blinks slowly, indicating ________.
Options- A. that an open or bad logic level exists
- B. a high level output
- C. a high-frequency pulse train
- D. that the supply voltage is low Discuss
- 5. Totem-pole outputs ________ be connected ________ because ________.
Options- A. can, in parallel, sometimes higher output current is required
- B. cannot, together, if the outputs are in opposite states excessively high currents can damage one or both of the devices
- C. should, in series, certain applications may require higher output voltage
- D. can, together, together they can handle larger load currents and higher output voltages Discuss
- 6. When VGS = 0 on an N-channel MOSFET switch, there is no ________ between the source and the drain.
Options- A. voltage drop
- B. conductive channel
- C. capacitance
- D. inductance Discuss
- 7. The proliferation of small handheld consumer equipment such as digital video cameras, cellular phones, handheld computers (________), portable audio systems, and other devices has created a need for logic circuits in very small packages.
Options- A. HDLs
- B. GDAs
- C. PDAs
- D. TTLs Discuss
- 8. Fan-out for a typical TTL gate is ________.
Options- A. 100
- B. 54
- C. 10
- D. 4 Discuss
- 9. The time it takes for an input signal to pass through internal circuitry and generate the appropriate output effect is known as ________.
Options- A. fan-out
- B. propagation delay
- C. rise time
- D. fall time Discuss
- 10. P-MOS and N-MOS ________.
Options- A. represent MOSFET devices utilizing either P-channel or N-channel devices exclusively within a given gate
- B. are enhancement-type CMOS devices used to produce a series of high-speed logic known as 74HC
- C. represent positive and negative MOS-type devices that can be operated from differential power supplies and are compatible with operational amplifiers
- D. None of the above are. Discuss
Integrated-Circuit Logic Families problems
Search Results
Correct Answer: All of the above.
Correct Answer: BiCMOS
Correct Answer: LOW
Correct Answer: a high-frequency pulse train
Correct Answer: cannot, together, if the outputs are in opposite states excessively high currents can damage one or both of the devices
Correct Answer: conductive channel
Correct Answer: PDAs
Correct Answer: 10
Correct Answer: propagation delay
Correct Answer: represent MOSFET devices utilizing either P-channel or N-channel devices exclusively within a given gate
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.