Discussion
Home ‣ Digital Electronics ‣ The 8051 Microcontroller Comments
- Question
In an 8051 program DA A adjusts the value in the accumulator resulting from an addition into two BCDs.
Options- A. True
- B. False
- Correct Answer
- True
- 1. Up to 65K of code memory and 65K of data memory can be added to any of the 8051 family members.
Options- A. True
- B. False Discuss
- 2. The RST pin requires a HIGH to reset the 8051 microcontroller.
Options- A. True
- B. False Discuss
- 3. Different instruction sets must make up for the various members of the 8051 family.
Options- A. True
- B. False Discuss
- 4. The 8051 is a 40-pin IC. Twenty-two pins are needed for the four I/O ports.
Options- A. True
- B. False Discuss
- 5. A monostable multivibrator is commonly called a two shot.
Options- A. True
- B. False Discuss
- 6. Writing counter/loop programs is much more difficult with the introduction of the DJNA and the CJNE instructions.
Options- A. True
- B. False Discuss
- 7. Analog output current must be converted into a usable voltage. To perform this current-to-voltage conversion a 700 op amp may be used.
Options- A. True
- B. False Discuss
- 8. A Celsius thermometer is an application for the 8051 microcontroller.
Options- A. True
- B. False Discuss
- 9. The ADC 0804 is an analog-to-digital converter that provides 8-bit output resolution that can be directly interfaced to a microcontroller.
Options- A. True
- B. False Discuss
- 10. A microcontroller is called a computer on a chip.
Options- A. True
- B. False Discuss
The 8051 Microcontroller problems
Search Results
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.