logo

CuriousTab

CuriousTab

Discussion


Home Digital Electronics Boolean Algebra and Logic Simplification See What Others Are Saying!
  • Question
  • The OR function is Boolean multiplication and the AND function is Boolean addition.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 


  • More questions

    • 1. A logic pulser is used to determine the level of floating in a circuit.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. ASIC stands for:

    • Options
    • A. advanced speed integrated circuit.
    • B. advanced standard integrated circuit.
    • C. application specific integrated circuit.
    • D. application speedy integrated circuit.
    • Discuss
    • 3. A 5-bit asynchronous binary counter is made up of five flip-flops, each with a 12 ns propagation delay. The total propagation delay (tp(tot)) is ________.

    • Options
    • A. 12 ms
    • B. 24 ns
    • C. 48 ns
    • D. 60 ns
    • Discuss
    • 4. Assume an 8-bit serial in/parallel out shift register needs to be cleared but has no clear input. How many clock cycles are required before a zero applied to the input appears on the QH output?

    • Options
    • A. 1
    • B. 7
    • C. 8
    • D. 9
    • Discuss
    • 5. Power is connected to pins 7 and 14 of a 7408 quad two-input AND gate IC to allow voltage for all four AND gates on the IC.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. For an S-R flip-flop to be set or reset, the respective input must be:

    • Options
    • A. installed with steering diodes
    • B. in parallel with a limiting resistor
    • C. LOW
    • D. HIGH
    • Discuss
    • 7. In order to check the CLR function of a counter, ________.

    • Options
    • A. apply the active level to the CLR input and check all of the Q outputs to see if they are all in their reset state
    • B. ground the CLR input and check to be sure that all of the Q outputs are LOW
    • C. connect the CLR input to Vcc and check to see if all of the Q outputs are HIGH
    • D. connect the CLR to its correct active level while clocking the counter; check to make sure that all of the Q outputs are toggling
    • Discuss
    • 8. What is an OTP device?

    • Options
    • A. Optical transporting port
    • B. Octal transmitting pixel
    • C. Operational topical portable
    • D. One-time programmable
    • Discuss
    • 9. Many parallel counters use ________ presetting whereby the counter is preset on the active transition of the same clock signal that is used for counting.

    • Options
    • A. feedback
    • B. synchronous
    • C. ripple
    • D. asynchronous
    • Discuss
    • 10. The asynchronous inputs on a J-K flip-flop ________.

    • Options
    • A. are normally not at the active level at the same time
    • B. take precedence over the J and K inputs
    • C. do not require a clock pulse to affect the output
    • D. all of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment