Discussion
Home ‣ Chemical Engineering ‣ Mechanical Operations Comments
- Question
Gizzlies are used for separating __________ solids.
Options- A. coarse
- B. fine
- C. any size
- D. none of these
- Correct Answer
- fine
- 1. In case of a revolving mill, wet grinding compared to dry grinding
Options- A. requires more energy.
- B. has less capacity.
- C. complicates handling & classification of the product.
- D. none of these. Discuss
- 2. Rittinger's crushing law states that
Options- A. work required to form a particle of any size is proportional to the square of the surface to volume ratio of the product.
- B. work required to form a particle of a particular size is proportional to the square root of the surface to volume ratio of the product.
- C. work required in crushing is proportional to the new surface created.
- D. for a given machine and feed, crushing efficiency is dependent on the size of the feed & product. Discuss
- 3. Mechanical conveyors which push the material along an endless trough or tube are called scrappers. Which of the following conveying equipments comes under the category of 'scrappers'?
Options- A. Bucket conveyor
- B. Flight conveyor
- C. Screw conveyor
- D. Both (b) and (c) Discuss
- 4. Pick out the material having minimum Rittinger's number.
Options- A. Calcite
- B. Pyrite
- C. Quartz
- D. Galena Discuss
- 5. Which of the following grinding mills has the horizontally arranged rods as the grinding elements thereby delivering more uniform granular products with minimum fines?
Options- A. Compartment mill
- B. Rod mill
- C. Pebble mill
- D. Tube mill. Discuss
- 6. There is practically no alternative/competitor to __________ in the beneficiation treatment of sulphide ores.
Options- A. classification
- B. tabling
- C. jigging
- D. froth floatation Discuss
- 7. Which of the following is the hardest material?
Options- A. Calcite
- B. Quartz
- C. Corundum
- D. Gypsum Discuss
- 8. Use of 'grinding aids' is done in __________ grinding.
Options- A. dry
- B. wet
- C. ultrafine
- D. intermediate Discuss
- 9. Critical Speed (Nc) of a ball mill is given by(where R1 and R2 are radii of ball mill and the ball respectively).
Options- A.
- B.
- C.
- D.
Discuss
- 10. At low Reynold's number, the power (P) required for agitating a fluid in a stirred tank becomes independent of inertial forces. In this limit, indicate which of the following relations is satisfied:
Po = ?/?N3 D5 : Power number
Re = ? N D2/?: Reynold's number
N is the impeller rotational speed, and D is the impeller diameter.
Options- A. Po ? Re-1.0
- B. Po ? Re0.0
- C. Po ? Re0.5
- D. Po ? Re1.0 Discuss
Mechanical Operations problems
Search Results
Correct Answer: none of these.
Correct Answer: work required in crushing is proportional to the new surface created.
Correct Answer: Both (b) and (c)
Correct Answer: Quartz
Correct Answer: Rod mill
Correct Answer: froth floatation
Correct Answer: Corundum
Correct Answer: dry
Correct Answer:
Correct Answer: Po ? Re0.0
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.