Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Mechanical Operations
Critical Speed (Nc) of a ball mill is given by(where R1 and R2 are radii of ball mill and the ball respectively).
Correct Answer:
← Previous Question
Next Question→
More Questions from
Mechanical Operations
At low Reynold's number, the power (P) required for agitating a fluid in a stirred tank becomes independent of inertial forces. In this limit, indicate which of the following relations is satisfied: Po = ρ/ρN3 D5 : Power number Re = ρ N D2/μ: Reynold's number N is the impeller rotational speed, and D is the impeller diameter.
The important dimensional group involved in the power requirement calculation in mixing operation is the __________ number.
Sphericity of pulverised coal is
For a sphere falling in the constant drag co-efficient regime, its terminal velocity depends on its diameter (d) as
For a cyclone of diameter 0.2 m with a tangential velocity of 15 m/s at the wall, the separation factor is
Grinding efficiency of a ball mill is of the order of __________ percent.
Filtration capacity of a rotary drum vacuum filter depends upon the
For efficient grinding, ball mills must be operated
About 2-3 hp, power per gallon of a thin liquid provides vigrous agitation in an agitator. 'Power number' in agitation is given by
The value of work index does not change materially from one equipment to another. If the value of work index determined for close circuit grinding is Wi, then the same for open circuit grinding will be
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments