Discussion
Home ‣ Chemical Engineering ‣ Process Equipment and Plant Design Comments
- Question
The ratio of lateral strain to linear strain is termed as the
Options- A. Poisson's ratio
- B. bulk modulus
- C. modulus of elasticity
- D. shear modulus
- Correct Answer
- Poisson's ratio
- 1. Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.
Options- A. 6% of I.D.
- B. 3 times the thickness
- C. either (a) or (b), whichever is larger
- D. either (a) or (b), whichever is smaller Discuss
- 2. Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always
Options- A. less than arithmetic mean value.
- B. more than arithmetic mean value.
- C. more than geometric mean value.
- D. both(b) & (c). Discuss
- 3. Wind load consideration in the design of a support can be neglected, when the vessel is
Options- A. tall (say 30 metres), but is full of liquid.
- B. tall but empty.
- C. short (< 2 m) and housed indoor.
- D. none of these. Discuss
- 4. Power required for agitation depends upon the
Options- A. height & properties of the liquid.
- B. agitator type & speed of agitation.
- C. size of agitator & the tank.
- D. all (a), (b) and (c). Discuss
- 5. Vertical storage vessels are never supported by __________ support.
Options- A. bracket
- B. saddle
- C. skirt
- D. lug Discuss
- 6. Frame thickness in the plate and frame filter press is normally in the range of __________ inches.
Options- A. 0.25 to 4
- B. 0.25 to 8
- C. 1 to 5
- D. 1 to 12 Discuss
- 7. In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)
Options- A.
- B.
- C.
- D. ?d/4P2 Discuss
- 8. Filtration rate is affected by the
Options- A. pressure drop across the cake & filter medium.
- B. cake & filter medium resistance.
- C. area of filtering surface & the viscosity of filtrate.
- D. all (a), (b) and (c). Discuss
- 9. __________ heat exchanger is also known as 'hair pin type' exchanger,
Options- A. Double pipe
- B. Finned
- C. Plate type
- D. Regenerative Discuss
- 10. Optimum economic pipe diameter for fluid flow is determined by the
Options- A. viscosity of the fluid.
- B. density of the fluid.
- C. total cost considerations (pumping cost plus fixed cost of the pipe).
- D. none of these. Discuss
Process Equipment and Plant Design problems
Search Results
Correct Answer: either (a) or (b), whichever is larger
Correct Answer: less than arithmetic mean value.
Correct Answer: short (< 2 m) and housed indoor.
Correct Answer: all (a), (b) and (c).
Correct Answer: saddle
Correct Answer: 0.25 to 8
Correct Answer:
Correct Answer: all (a), (b) and (c).
Correct Answer: Double pipe
Correct Answer: total cost considerations (pumping cost plus fixed cost of the pipe).
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.