logo

CuriousTab

CuriousTab

Discussion


Home Biochemical Engineering Agitation and Aeration Comments

  • Question
  • Laminar flow range of mixing speed is obtained for


  • Options
  • A. Rei<10
  • B. 10<Rei<104
  • C. Rei>104
  • D. None of these

  • Correct Answer
  • Rei<10 


  • Agitation and Aeration problems


    Search Results


    • 1. The power required by an agitator operating in a gas-sparged system is

    • Options
    • A. lesser than the power required by an impeller in operating at same speed in a gas free system
    • B. more than the power required by an impeller in operating at same speed in a gas free system
    • C. same as the power required by an impeller in operating at same speed in a gas free system
    • D. none of the above
    • Discuss
    • 2. What is the effect of the concentration of dissolved salts and sugars on the oxygen transfer rate?

    • Options
    • A. The saturation concentration of oxygen in the medium decreases with the concentration of dissolved salts and sugars, leading to a lower oxygen transfer rate
    • B. The KLa of the medium decreases with the concentration of dissolved salts and sugars, leading to a lower oxygen transfer rate
    • C. The KLa of the medium increases with the concentration of dissolved salts and sugars, leading to a lower oxygen transfer rate
    • D. None of the above
    • Discuss
    • 3. Which of the following impellers generate a flow parallel to the axis of shaft?

    • Options
    • A. Axial flow
    • B. Radial flow
    • C. Both (a)and(b)
    • D. None of these
    • Discuss
    • 4. For laminar flow, Reynolds number is correlated with power number as (where K, a constant which depends on the container geometry and shape of stirrer; Rei is Reynolds number for agitator; Di, stirrer diameter and N, stirrer speed)

    • Options
    • A. Np = K(Rei)-1
    • B. Np = N2Di(Rei)-1
    • C. Np = K(Rei)
    • D. Np = KNDi(Rei)-2
    • Discuss
    • 5. An increase in the heat transfer in the stirred tank reactor will be observed at

    • Options
    • A. higher cooling water temperature
    • B. higher stirrer speed
    • C. the removal of baffles from the reactor
    • D. slower stirrer speed
    • Discuss


    Comments

    There are no comments.

Enter a new Comment