Discussion
Home ‣ Biochemical Engineering ‣ Agitation and Aeration Comments
- Question
If the stirrer speed is too slow, bubbles will accumulate and coalescese under the impeller. This phenomenon is known as a
Options- A. coalesced impeller
- B. flooded impeller
- C. river impeller
- D. dry impeller
- Correct Answer
- flooded impeller
- 1. A fermentation system has a KLa of 3 s-1 and a C0* of 5 ppm of O2. If the bulk liquid is saturated with oxygen then the oxygen transfer rate will be equal to
Options- A. zero
- B. 3 mg.l-1.s-1
- C. 5 mg.l-1.s-1
- D. 15 mg.l-1.s-1 Discuss
- 2. In aerobic microorganisms cultures radial flow impellers are used because
Options- A. they provide energy efficient high turbulent mixing conditions
- B. they provide low shear mixing conditions
- C. they provide high shear mixing conditions
- D. they ensure that bubble size is maximized leading to high oxygen transfer rates Discuss
- 3. Impeller damage can be minimized by
Options- A. using specially designed axial flow impellers
- B. using radial flow impellers
- C. using Intermig impellers
- D. all of the above Discuss
- 4. A fermentation system has a KLa of 3 s-1 and a C0* of 5 ppm of O2. If the bulk liquid is completely depleted of oxygen, then the oxygen transfer rate will be equal to
Options- A. zero
- B. 15 mg.l-1.s-1
- C. 10 mg.l-1.s-1
- D. 5 mg.l-1.s-1 Discuss
- 5. During fermentation, the saturation concentration of oxygen was reduced from 7 ppm. to 1 ppm. Which one of the following conclusions can be drawn?
Options- A. Microbial growth is oxygen limited since the oxygen concentration is lesser than the saturation concentration
- B. Microbial growth is not oxygen limited since the oxygen concentration is lesser than the saturation concentration
- C. Experimental error leads to the reduction
- D. No conclusion can be drawn Discuss
- 6. A reactor has a total volume of 50,000 litres. If it has a headspace volume of 10,000 litres, then volume of liquid in the reactor will be
Options- A. 10,000 l
- B. 20,000 l
- C. 30,000 l
- D. 40,000 l Discuss
- 7. Reynolds (Rei) number for the impeller is given by (where Di, stirrer diameter; N, stirrer speed, ?, density of fluid and ?, viscosity of fluid)
Options- A. DiV?/?
- B. Di2N?/?
- C. Di2V?/?
- D. DiN? /? Discuss
- 8. The advantage of axial flow impellers over radial flow impellers is that axial flow impellers
Options- A. provide better lift of solids
- B. provide high shear conditions
- C. provide low shear conditions
- D. are cheaper to build Discuss
- 9. In a bioreactor, if at a particular time the oxygen transfer rate is 23 kg.h-1, then the oxygen uptake will be
Options- A. 23 kg.h-1
- B. less than 23 kg.h-1
- C. greater than 23 kg.h-1
- D. 2.3 kg.h-1 Discuss
- 10. In a two-phase system where the continuous phase remains in place, the gas hold up can be expressed as (where Vs and Vt are the superficial gas velocity and bubble rise velocity)
Options- A. H = Vs/(Vs-Vt)
- B. H = Vs/(Vs+ Vt)
- C. H = Vs/(Vs.Vt)
- D. H = (Vs+Vt)/Vs Discuss
Agitation and Aeration problems
Search Results
Correct Answer: zero
Correct Answer: they provide high shear mixing conditions
Correct Answer: using specially designed axial flow impellers
Correct Answer: 15 mg.l-1.s-1
Correct Answer: No conclusion can be drawn
Correct Answer: 40,000 l
Correct Answer: Di2N?/?
Correct Answer: provide better lift of solids
Correct Answer: 23 kg.h-1
Correct Answer: H = Vs/(Vs+ Vt)
Comments
There are no comments.Programming
Copyright ©CuriousTab. All rights reserved.