logo

CuriousTab

CuriousTab

Discussion


Home Biochemical Engineering Fermentation Kinetics See What Others Are Saying!
  • Question
  • In an airlift bioreactor, the air sparging region is called


  • Options
  • A. downcomer
  • B. disengagement zone
  • C. air riser
  • D. none of these

  • Correct Answer
  • air riser 


  • More questions

    • 1. What is the ratio of depth of liquid in vessel to the diameter of tank (H:Dt)?

    • Options
    • A. 1 : 1
    • B. 2 : 1
    • C. 4 : 1
    • D. none of these
    • Discuss
    • 2. Main reason for using baffles in stirred tank reactors are

    • Options
    • A. baffles permit turbulence conditions to arise at low stirrer speed
    • B. baffles will allow axial mixing to occur even with radial flow impellers
    • C. both (a) and (b)
    • D. baffles prevent turbulent conditions in stirred tank reactors
    • Discuss
    • 3. Mixing per unit volume is observed to be poorest in

    • Options
    • A. continuous packed bed reactor
    • B. continuous fluidized bed bioreactor
    • C. continuous airlift bioreactor
    • D. none of the above
    • Discuss
    • 4. In a Lineweaver-Burk Plot, competitive inhibitor shows which of the following effect?

    • Options
    • A. It moves the entire curve to right
    • B. It moves the entire curve to left
    • C. It changes the x-intercept
    • D. It has no effect on the slope
    • Discuss
    • 5. A stirred tank reactor containing a fluid with a density of 2.5 g.ml-1 and viscosity of 0.002 kg m-1s-1 is mixed at 120 rpm. If the fluid is mixed with an impeller having diameter 50 cm, then the Reynolds number of the liquid in the reactor is

    • Options
    • A. 2500
    • B. 100
    • C. 12,50,000
    • D. 1,000,000
    • Discuss
    • 6. Which of the following is used to calculate mass of substrate in the reactor?

    • Options
    • A. Flow rate x substrate concentration in the reactor
    • B. Volume of reactor x substrate concentration in reactor
    • C. Flow rate x mass of reactor
    • D. Volume of reactor x Flow rate
    • Discuss
    • 7. A flooded impeller will lead to poor oxygen transfer rates because

    • Options
    • A. bubbles tend to coalesce under the impeller
    • B. bubbles tend to break down too rapidly under high shear conditions
    • C. bubbles tend to move too quickly through the bulk liquid
    • D. the cells clog up the surface of the bubble
    • Discuss
    • 8. Classical noncompetitive inhibition is obtained only under

    • Options
    • A. slow equilibrium conditions
    • B. moderate equilibrium conditions
    • C. rapid equilibrium conditions
    • D. non-equilibrium conditions
    • Discuss
    • 9. The enzyme ?-galactosidase is also known as

    • Options
    • A. lactase
    • B. EC3.2.1.23
    • C. both (a) and (b)
    • D. isomerase
    • Discuss
    • 10. The solvent flux across the membrane can be expressed as (where A is the area, Lp is the membrane permeability, ? is the reflection point, ?p is applied pressure and ?? is the osmotic pressure)

    • Options
    • A. J = Lp(?p - ???)
    • B. J/A = Lp(?p - ???)
    • C. J = Lp/???
    • D. J/A = Lp/?p
    • Discuss


    Comments

    There are no comments.

Enter a new Comment