Discussion
Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments
- Question
In a single phase full converter fed by a source having inductance, the number of thyristors conducting during overlap is
Options- A. 1
- B. 2
- C. 3
- D. 4
- Correct Answer
- 4
- 1. In auxiliary commutated chopper, the peak value of thyristor current is
Options- A. equal to peak value of load current
- B. equal to peak value of capacitor current
- C. sum of peak value of load current and capacitor current
- D. none of the above Discuss
- 2. Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.
Reason (R): A semi converter is cheaper than a full converter.
Options- A. Both A and R are correct and R is correct explanation of A
- B. Both A and R correct but R is not correct explanation of A
- C. A is correct but R is wrong
- D. A is wrong but R is correct Discuss
- 3. Which chopper circuit operates in quadrants 1 and 4?
Options- A. A
- B. B
- C. D
- D. E Discuss
- 4. An SCR is triggered at 80° in the positive half cycle, only. The rms anode current is 25 A. If the firing angle is changed to 160°, the rms current is likely to be
Options- A. 25 A
- B. 12.5 A
- C. less than 25 A
- D. less than 12.5 A Discuss
- 5. The output wave of a cycloconverter consists of a number of segments derived from the input wave.
Options- A. True
- B. False Discuss
- 6. A load commutated chopper circuit has
Options- A. one thyristor
- B. two thyristors
- C. four thyristors
- D. six thyristors Discuss
- 7. In a single phase full wave controlled rectifier using centre tap transformer, the voltage across each half of secondary is Vm sin ?t. The peak inverse voltage is
Options- A. 2 Vm
- B. Vm
- C. 0.5 Vm
- D. 0.25 Vm Discuss
- 8. If peak value of input voltage is Vm and firing angle is a, the average output voltage for single phase half wave and single phase full wave regulators are
Options- A.
- B.
- C.
- D.
Discuss
- 9. Lead mounting for SCR is used for
Options- A. rating less than mA
- B. rating about 1 A or less
- C. rating of 20 A or less than 20 A
- D. rating 100 A or less Discuss
- 10. A TRIAC can be turned on :
Options- A. by applying a positive signal to gate
- B. by applying a negative signal to gate
- C. by applying either positive or negative signal to gate
- D. none of the above Discuss
Power Electronics problems
Search Results
Correct Answer: sum of peak value of load current and capacitor current
Correct Answer: Both A and R correct but R is not correct explanation of A
Correct Answer: D
Correct Answer: less than 12.5 A
Correct Answer: True
Correct Answer: four thyristors
Correct Answer: 2 Vm
Correct Answer:
Correct Answer: rating about 1 A or less
Correct Answer: by applying either positive or negative signal to gate
Comments
There are no comments.More in Electronics and Communication Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.