logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Power Electronics Comments

  • Question
  • An SCR is triggered at 80° in the positive half cycle, only. The rms anode current is 25 A. If the firing angle is changed to 160°, the rms current is likely to be


  • Options
  • A. 25 A
  • B. 12.5 A
  • C. less than 25 A
  • D. less than 12.5 A

  • Correct Answer
  • less than 12.5 A 


  • Power Electronics problems


    Search Results


    • 1. The output wave of a cycloconverter consists of a number of segments derived from the input wave.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. The commutation method in an inverter, is

    • Options
    • A. line commutation
    • B. forced commutation
    • C. either (a) or (b)
    • D. none of the above
    • Discuss
    • 3. The symbol in figure is for

    • Options
    • A. SUS
    • B. SBS
    • C. SCS
    • D. Shockley diode
    • Discuss
    • 4. A class A chopper has an input voltage of 200 V. Ton = 1.5 ms and Toff = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are

    • Options
    • A. 0.5, 100 V and 1
    • B. 0.25, 50 V and 3
    • C. 0.25, 50 V and 1
    • D. 0.5, 100 V and 3
    • Discuss
    • 5. In a single phase full wave regulator, the rms current in each thyristors is Ir The run load current is equal to

    • Options
    • A. 2Ir
    • B. 2 Ir
    • C. Ir
    • D.
    • Discuss
    • 6. Which chopper circuit operates in quadrants 1 and 4?

    • Options
    • A. A
    • B. B
    • C. D
    • D. E
    • Discuss
    • 7. Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.

      Reason (R): A semi converter is cheaper than a full converter.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 8. In auxiliary commutated chopper, the peak value of thyristor current is

    • Options
    • A. equal to peak value of load current
    • B. equal to peak value of capacitor current
    • C. sum of peak value of load current and capacitor current
    • D. none of the above
    • Discuss
    • 9. In a single phase full converter fed by a source having inductance, the number of thyristors conducting during overlap is

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D. 4
    • Discuss
    • 10. A load commutated chopper circuit has

    • Options
    • A. one thyristor
    • B. two thyristors
    • C. four thyristors
    • D. six thyristors
    • Discuss


    Comments

    There are no comments.

Enter a new Comment