Home » Civil Engineering » GATE Exam Questions

Shear centre for an angle-purlin as shown in the below figure is located at,

X
Y
Z
none

Correct Answer: X

← Previous Question Next Question→

More Questions from GATE Exam Questions

For an anisotropic soil, permeabilities in x and y directions are kx and ky respectively in a two dimensional flow. The effective permeability keq for the soil is given by
A parabolic curve is used to connect a 4% upgrade with a 2% downgrade as shown in the below figure. The highest point on the summit is at a distance of (measured horizontally from the first tangent point - (FTP)
The ordinate of the Instantaneous Unit Hydrograph (IUH) of a catchment at any time t, is
The plan of stairs supported at each end by landings spanning parallel with risers is shown in the below figure. The effective span of staircase slab is
Chemical oxygen Demand (COD) of a sample is always greater than Biochemical Oxygen Demand (BOD) since it represents :
Rotational stiffness-coefficient, K11 for the frame having two members of equal EI/l is given by :
A deep cut of 7 m has to be made in a clay with unit weight 16 kN/m3 and a cohesion of 25 kN/m2. What will be the factor of safety if one has to have a slope angle of 30°? Stability number is given to be 0.178 (from Taylor's chart) for a depth factor of 3.
In a BOD test, 5 ml of waste is added to 295 ml of aerated pure water. Initial dissolved oxygen (D.O) content of the diluted sample is 7.8 mg/l. After 5 days of incubation at 20°C, the D.O. content of the sample is reduced to 4.4 mg/l. The BOD of the waste water is :
The forces in members 'a, b, c' in the truss shown are, respectively
The shape of the cross-section, which has the largest shape factor, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion