Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Strength of Materials
A member which is subjected to reversible tensile or compressive stress may fail at a stress lower than the ultimate stress of the material. This property of metal, is called
plasticity of the metal
elasticity of the metal
fatigue of the metal
workability of the metal.
Correct Answer:
fatigue of the metal
← Previous Question
Next Question→
More Questions from
Strength of Materials
A cantilever carries is uniformly distributed load W over its whole length and a force W acts at its free end upward. The net deflection of the free end will be
Pick up the correct statement from the following :
In a simply supported beam (l + 2a) with equal overhangs (a) and carrying a uniformly distributed load over its entire length, B.M. at the middle point of the beam will be zero if
The principal stresses at a point are 100, 100 and-200 kgf/cm2, the octo hedral shear stress at the point is :
If a member is subjected to a tensile force P, having its normal cross-section A, the resulting shear stress in an oblique plane inclined at an angle θ to its transverse plane, is
In a simply supported beam L with a triangular load W varying from zero at one end to the maximum value at the other end, the maximum bending moment is
Strain energy of a member may be equated to
If the width b and depth d of a beam simply supported with a central load are interchanged, the deflection at the centre of the beam will be changed in the ratio of
The bending moment at E for the structure shown in below figure, is
Along the principal plan subjected to maximum principal stress
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments