logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Soil Mechanics and Foundation Engineering Comments

  • Question
  • The neutral stress in a soil mass is


  • Options
  • A. force per neutral area
  • B. force per effective area
  • C. stess taken up by the pore water
  • D. stress taken up by solid particles.

  • Correct Answer
  • stess taken up by the pore water 


  • Soil Mechanics and Foundation Engineering problems


    Search Results


    • 1. A flow net may be utilised for the determination of

    • Options
    • A. exit gradient
    • B. seepage
    • C. hydrostatic pressure
    • D. seepage pressure
    • E. all the above.
    • Discuss
    • 2. The ratio of the weight of water to the weight of solids in a given mass of soil, is known

    • Options
    • A. porosity
    • B. specific gravity
    • C. void ratio
    • D. water content.
    • Discuss
    • 3. Pick up the correct statement from the following:

    • Options
    • A. The range of water content between the liquid limit and plastic limit, is called plasticity index.
    • B. The ratio of the liquid limit minus the natural water content to the plasticity index of soils, is called consistency index
    • C. The ratio of natural water content minus its plastic limit to its plasticity index is called liquidity index
    • D. The ratio between plasticity index and flow index (i.e. slope of flow curve in case of liquid limit), is called toughness index
    • E. All the above.
    • Discuss
    • 4. Through a point in a loaded soil mass, there exists n typical planes mutually orthogonal on which the stress is wholly normal and no shear stress acts, if n is

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D. 4
    • Discuss
    • 5. The Mohr's straight theory is based on the following fact :

    • Options
    • A. Material fails essentially by shear
    • B. Ultimate strength of the material is determined by the stress in the plane of slip
    • C. Failure criterion is independent of the intermediate principal stress
    • D. All the above.
    • Discuss
    • 6. A triaxial shear test is prefered to direct shear test, because

    • Options
    • A. it can be performed under all three driange conditions with complete control
    • B. precise measurement of pore pressure and change in volume during test, is not posible
    • C. stress distribution on the failure plane, is non uniform
    • D. none of these.
    • Discuss
    • 7. A plane inclined at an angle ? to the horizontal at which the soil is expected to stay in the absence of any lateral support, is known as

    • Options
    • A. natural slope line
    • B. repose line
    • C. the ? line
    • D. all the above.
    • Discuss
    • 8. Pick up the correct statement from the following:

    • Options
    • A. The permeability of the coarse-grained soils may be reduced by grouting.
    • B. The process of injecting fluids (i.e. grouts) into the pores space of the soil, is called grouting.
    • C. The grouting increases the soil strength.
    • D. All the above.
    • Discuss
    • 9. A suspended particle falls through a height H cm in water in t minutes. If the viscosity of water is ? and specific gravity of the particle is G, the diameter of the particle is (where M is a constant factor)

    • Options
    • A. 103M
    • B. 104M
    • C. 105M
    • D. 102M
    • Discuss
    • 10. The bearing capacity of a soil depends upon

    • Options
    • A. size of the particles
    • B. shape of the particles
    • C. cohesive properties of particles
    • D. internal frictional resistance of particles
    • E. all the above.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment