Discussion
Home ‣ Civil Engineering ‣ Surveying Comments
- Question
Pick up the correct statement from the following :
Options- A. the length of the brass handle is included in the length of chain
- B. the handles are on swivel joints to prevent twisting of the chain
- C. the fifth tag from either end of the chain is numbered 5
- D. the length of the Gunter's chain is 66 ft.
- E. all the above.
- Correct Answer
- all the above.
- 1. Plotting of inaccessible points on a plane table, is done by
Options- A. intersection
- B. traversing
- C. radiation
- D. none of these. Discuss
- 2. Setting out a curve by two theodolite method, involves
Options- A. linear measurements only
- B. angular measurements only
- C. both linear and angular measurements
- D. none of these. Discuss
- 3. The desired sensitivity of a bubble tube with 2 mm divisions is 30". The radius of the bubble tube should be
Options- A. 13.75 m
- B. 3.44 m
- C. 1375 m
- D. none of these. Discuss
- 4. If the angular measurements of a traverse are more precise than its linear measurements, balancing of the traverse, is done by
Options- A. Bowditch's rule
- B. Transit rule
- C. Empirical rule
- D. all of the above. Discuss
- 5. Two hill tops A and B 20 km apart are intervened by a third top C. If the top most contour of the three hill tops are of the same value, state whether the line of sight AB
Options- A. passes clear of hill top C
- B. passes below the hill top C
- C. grazes the hill top C
- D. none of these. Discuss
- 6. The longitudinal section of the surface of bubble tube is
Options- A. straight
- B. circular
- C. parabolic
- D. elliptic. Discuss
- 7. The curve composed of two arcs of different radii having their centres on the opposite side of the curve, is known
Options- A. a simple curve
- B. a compound curve
- C. a reverse curve
- D. a vertical curve. Discuss
- 8. Back bearing of a line is equal to
Options- A. Fore bearing ± 90°
- B. Fore bearing ± 180°
- C. Fore bearing ± 360°
- D. Fore bearing ± 270° Discuss
- 9. If a tacheometer is fitted with an anal-latic lens
Options- A. additive constant is 100, multiplying constant is zero
- B. multiplying constant is 100, additive constant is zero
- C. both multiplying and additive constants are 100
- D. both multiplying and additive constants are 50. Discuss
- 10. The orthographical projection of a traverse leg upon the reference meridian, is known as
Options- A. departure of leg
- B. latitude to the leg
- C. co-ordinate of the leg
- D. bearing of the leg. Discuss
Surveying problems
Search Results
Correct Answer: intersection
Correct Answer: angular measurements only
Correct Answer: 13.75 m
Correct Answer: Transit rule
Correct Answer: passes below the hill top C
Correct Answer: circular
Correct Answer: a reverse curve
Correct Answer: Fore bearing ± 180°
Correct Answer: multiplying constant is 100, additive constant is zero
Correct Answer: latitude to the leg
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.