Discussion
Home ‣ Mechanical Engineering ‣ Strength of Materials Comments
- Question
The columns whose slenderness ratio is less than 80, are known as
Options- A. short columns
- B. long columns
- C. weak columns
- D. medium columns
- Correct Answer
- short columns
- 1. A section of beam is said to be in pure bending, if it is subjected to
Options- A. constant bending moment and constant shear force
- B. constant shear force and zero bending moment
- C. constant bending moment and zero shear force
- D. none of the above Discuss
- 2. Modular ratio of the two materials is the ratio of
Options- A. linear stress to linear strain
- B. shear stress to shear strain
- C. their modulus of elasticities
- D. their modulus of rigidities Discuss
- 3. A localised compressive stress at the area of contact between two members is known as
Options- A. tensile stress
- B. bending stress
- C. crushing stress
- D. shear stress Discuss
- 4. The shear force of a cantilever beam of length l carrying a uniformly distributed load of w per unit length is __________ at the fixed end.
Options- A. zero
- B. wl/4
- C. wl/2
- D. wl Discuss
- 5. Poisson's ratio is the ratio of linear stein to the volumetric strain.
Options- A. True
- B. False Discuss
- 6. The lower layer of the beam as shown in the below figure, will be
Options- A. in tension
- B. in compression
- C. neither in tension nor in compression Discuss
- 7. A square beam and a circular beam have the same length, same allowable stress and the same bending moment. The ratio of weights of the square beam to the circular beam is
Options- A. 1/2
- B. 1
- C. 1/1.12
- D. 1/2 Discuss
- 8. The perpendicular distance between the centre lines of the successive rows, is called pitch.
Options- A. Agree
- B. Disagree Discuss
- 9. The values of equivalent length (L) and actual length (l) of a column for both ends hinged is the same
Options- A. Yes
- B. No Discuss
- 10. When a body is subjected to a direct tensile stress (?) in one plane, then tangential or shear stress on an oblique section of the body inclined at an angle ? to the normal of the section is
Options- A. ? sin 2?
- B. ? cos 2?
- C. ?/2 sin 2?
- D. ?/2 cos 2? Discuss
Strength of Materials problems
Search Results
Correct Answer: constant bending moment and zero shear force
Correct Answer: their modulus of elasticities
Correct Answer: crushing stress
Correct Answer: wl
Correct Answer: False
Correct Answer: in tension
Correct Answer: 1/1.12
Correct Answer: Disagree
Correct Answer: Yes
Correct Answer: ?/2 sin 2?
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.