Discussion
Home ‣ Digital Electronics ‣ Microprocessor Fundamentals Comments
- Question
The circuits in the 8085A that provide the arithmetic and logic functions are called the:
Options- A. CPU
- B. ALU
- C. I/O
- D. none of the above
- Correct Answer
- ALU
- 1. What type of circuit is used at the interface point of an input port?
Options- A. decoder
- B. latch
- C. tristate buffer
- D. none of the above Discuss
- 2. All computer programs for a machine are called:
Options- A. software
- B. firmware
- C. hardware
- D. none of the above Discuss
- 3. The technique of assigning a memory address to each I/O device in the computer system is called:
Options- A. memory-mapped I/O
- B. ported I/O
- C. dedicated I/O
- D. wired I/O Discuss
- 4. When was the first 8-bit microprocessor introduced?
Options- A. 1969
- B. 1974
- C. 1979
- D. 1985 Discuss
- 5. A register in the microprocessor that keeps track of the answer or results of any arithmetic or logic operation is the:
Options- A. stack pointer
- B. program counter
- C. instruction pointer
- D. accumulator Discuss
- 6. The register in the 8085A that is used to keep track of the memory address of the next op-code to be run in the program is the:
Options- A. stack pointer
- B. program counter
- C. instruction pointer
- D. accumulator Discuss
- 7. Single-bit indicators that may be set or cleared to show the results of logical or arithmetic operations are the:
Options- A. flags
- B. registers
- C. monitors
- D. decisions Discuss
- 8. Which of the following are the three basic sections of a microprocessor unit?
Options- A. operand, register, and arithmetic/logic unit (ALU)
- B. control and timing, register, and arithmetic/logic unit (ALU)
- C. control and timing, register, and memory
- D. arithmetic/logic unit (ALU), memory, and input/output Discuss
- 9. The software used to drive microprocessor-based systems is called:
Options- A. assembly language
- B. firmware
- C. machine language code
- D. BASIC interpreter instructions Discuss
- 10. What kind of computer program is used to convert mnemonic code to machine code?
Options- A. debug
- B. assembler
- C. C++
- D. Fortran Discuss
Microprocessor Fundamentals problems
Search Results
Correct Answer: tristate buffer
Correct Answer: software
Correct Answer: memory-mapped I/O
Correct Answer: 1974
Correct Answer: accumulator
Correct Answer: program counter
Correct Answer: flags
Correct Answer: control and timing, register, and arithmetic/logic unit (ALU)
Correct Answer: assembly language
Correct Answer: assembler
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.