logo

CuriousTab

CuriousTab

Discussion


Home Digital Electronics Digital Signal Processing Comments

  • Question
  • In troubleshooting a DAC, we check its performance characteristics, such as ________.


  • Options
  • A. nonmonotonicity
  • B. differential nonlinearity
  • C. low and high gain
  • D. all of the above

  • Correct Answer
  • all of the above 


  • Digital Signal Processing problems


    Search Results


    • 1. The dual-slope analog-to-digital converter finds extensive use in ________.

    • Options
    • A. digital voltmeters
    • B. function generators
    • C. frequency counters
    • D. all of the above
    • Discuss
    • 2. What do we call the manipulation of an analog signal in a digital domain?

    • Options
    • A. Analog-to-digital conversion
    • B. Digital-to-analog conversion
    • C. Digital signal processing
    • D. Signal filtering
    • Discuss
    • 3. A 4-bit R/2R ladder digital-to-analog converter uses ________.

    • Options
    • A. one resistor value
    • B. two resistor values
    • C. three resistor values
    • D. four resistor values
    • Discuss
    • 4. The ADC0804 is an example of a ________.

    • Options
    • A. single-slope analog-to-digital converter
    • B. dual-slope analog-to-digital converter
    • C. digital-ramp analog-to-digital converter
    • D. successive-approximation analog-to-digital converter
    • Discuss
    • 5. Which type of ADC quantizes the analog signal into a stream of bits whose amount corresponds to the signal level?

    • Options
    • A. Successive approximation
    • B. Sigma-delta
    • C. Dual-slope
    • D. None of the above
    • Discuss
    • 6. How many buses are connected as part of the 8085A microprocessor?

    • Options
    • A. 2
    • B. 3
    • C. 5
    • D. 8
    • Discuss
    • 7. The ________ ensures that only one IC is active at a time to avoid a bus conflict caused by two ICs writing different data to the same bus.

    • Options
    • A. control bus
    • B. control instructions
    • C. address decoder
    • D. CPU
    • Discuss
    • 8. I/O mapped systems identify their input/output devices by giving them a(n) ________.

    • Options
    • A. 8-bit port number
    • B. 16-bit port number
    • C. 8-bit buffer number
    • D. 8-bit instruction
    • Discuss
    • 9. What type of circuit is used at the interface point of an output port?

    • Options
    • A. decoder
    • B. latch
    • C. tristate buffer
    • D. none of the above
    • Discuss
    • 10. The items that you can physically touch in a computer system are called:

    • Options
    • A. software
    • B. firmware
    • C. hardware
    • D. none of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment