The designation means that the ________. up count is active-HIGH, the down count

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Digital Electronics ‣ Counters Comments

Question
The designation means that the ________.
Options
A. up count is active-HIGH, the down count is active-LOW
B. up count is active-LOW, the down count is active-HIGH
C. up and down counts are both active-LOW
D. up and down counts are both active-HIGH

Correct Answer

up count is active-HIGH, the down count is active-LOW

Counters problems

Search Results

1. What function does the CTR DIV 8 circuit given below perform?
Options
A. It divides the clock frequency down to match the frequency of the serial data in.
B. The divide-by-8 counter is triggered by the control flip-flop and clock, which then allows the data output register to begin storing the input data. Once all eight data bits are stored in the data output register, the data output register and the divide-by-8 counter trigger the one-shot. The one-shot then begins the process all over again.
C. The divide-by-8 counter is used to verify that the parity bit is attached to the input data string.
D. It keeps track of the eight data bits, triggering the transfer of the data through the output register and the one-shot, which then resets the control flip-flop and divide-by-8 counter.

4. After 10 clock cycles, and assuming that the DATA input had returned to 0 following the storage sequence, what values would be stored in Q4, Q3, Q2, Q1, Q0 of the register in Figure 7-5?
Options
A. 0,1,0,1,1
B. 1,1,0,1,0
C. 1,0,1,0,1
D. 0,0,0,0,0

5. What type of device is shown below?
Options
A. 4-bit bidirectional universal shift register
B. Parallel in/parallel out shift register with bidirectional data flow
C. 2-way parallel in/serial out bidirectional register
D. 2-bit serial in/4-bit parallel out bidirectional shift register

7. A MOD-16 synchronous counter has inputs labeled . These inputs would most probably be used to:
Options
A. reset the counter to 0000 at the end of each count cycle
B. preset the counter to a value determined by the inputs any time the is active-HIGH
C. preset the counter to a value determined by the inputs any time the is active-LOW
D. reset the counter to 0000 any time is active-HIGH and is active-LOW

8. Which segments of a seven-segment display would be required to be active to display the decimal digit 2?
Options
A. a, b, d, e, and g
B. a, b, c, d, and g
C. a, c, d, f, and g
D. a, b, c, d, e, and f

9. Which of the following groups of logic devices would be the minimum required for a MOD-64 synchronous counter?
Options
A. Five flip-flops, three AND gates
B. Seven flip-flops, five AND gates
C. Four flip-flops, ten AND gates
D. Six flip-flops, four AND gates

10. A multiplexed display being driven by a logic circuit:
Options
A. accepts data inputs from one line and passes this data to multiple output lines
B. accepts data inputs from several lines and allows one of them at a time to pass to the output
C. accepts data inputs from multiple lines and passes this data to multiple output lines
D. accepts data inputs from several lines and multiplexes this input data to four BCD lines

Comments

More in Digital Electronics: