Discussion
Home ‣ Digital Electronics ‣ Flip-Flops Comments
- Question
A positive edge-triggered D flip-flop will store a 1 when ________.
Options- A. the D input is HIGH and the clock transitions from HIGH to LOW
- B. the D input is HIGH and the clock transitions from LOW to HIGH
- C. the D input is HIGH and the clock is LOW
- D. the D input is HIGH and the clock is HIGH
- Correct Answer
- the D input is HIGH and the clock transitions from LOW to HIGH
- 1. On a J-K flip-flop, when is the flip-flop in a hold condition?
Options- A. J = 0, K = 0
- B. J = 1, K = 0
- C. J = 0, K = 1
- D. J = 1, K = 1 Discuss
- 2. Gated S-R flip-flops are called asynchronous because the output responds immediately to input changes.
Options- A. True
- B. False Discuss
- 3. Which of the following is correct for a D latch?
Options- A. The output toggles if one of the inputs is held HIGH.
- B. Q output follows the input D when the enable is HIGH.
- C. Only one of the inputs can be HIGH at a time.
- D. The output complement follows the input when enabled. Discuss
- 4. The pulse width of a one-shot circuit is determined by ________.
Options- A. a resistor and capacitor
- B. two resistors
- C. two capacitors
- D. none of the above Discuss
- 5. An active-HIGH input S-R latch has a 1 on the S input and a 0 on the R input. What state is the latch in?
Options- A.
- B.
- C.
- D.
Discuss
- 6. A J-K flip-flop with J = 1 and K = 1 has a 20 kHz clock input. The Q output is ________.
Options- A. constantly LOW
- B. constantly HIGH
- C. a 20 kHz square wave
- D. a 10 kHz square wave Discuss
- 7. When is a flip-flop said to be transparent?
Options- A. when the Q output is opposite the input
- B. when the Q output follows the input
- C. when you can see through the IC packaging Discuss
- 8. In VHDL, in which declaration section is a COMPONENT declared?
Options- A. Architecture
- B. Library
- C. Entity
- D. Port map Discuss
- 9. Asynchronous inputs will cause the flip-flop to respond immediately with regard to the clock input.
Options- A. True
- B. False Discuss
- 10. The circuit that is primarily responsible for certain flip-flops to be designated as edge-triggered is the:
Options- A. edge-detection circuit.
- B. NOR latch.
- C. NAND latch.
- D. pulse-steering circuit. Discuss
Flip-Flops problems
Search Results
Correct Answer: J = 0, K = 0
Correct Answer: False
Correct Answer: Q output follows the input D when the enable is HIGH.
Correct Answer: a resistor and capacitor
Correct Answer:
Correct Answer: a 10 kHz square wave
Correct Answer: when the Q output follows the input
Correct Answer: Architecture
Correct Answer: False
Correct Answer: edge-detection circuit.
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.