Discussion
Home ‣ Digital Electronics ‣ The 8051 Microcontroller Comments
- Question
This statement will set the address of the bit to 1 (8051 Micro-controller):
SETB 01H
Options- A. True
- B. False
- Correct Answer
- False
- 1. Device pins XTAL1 and XTAL2 for the 8051 are used for connections to an external oscillator or crystal.
Options- A. True
- B. False Discuss
- 2. The designs of a centigrade thermometer and a PWM speed-control circuit can be implemented by the 8051.
Options- A. True
- B. False Discuss
- 3. Bit-addressable memory locations are:
Options- A. 10H through 1FH
- B. 20H through 2FH
- C. 30H through 3FH
- D. 40H through 4FH Discuss
- 4. The special function registers can be referred to by their hex addresses or by their register names.
Options- A. True
- B. False Discuss
- 5. Which of the following commands will move the number 27H into the accumulator?
Options- A. MOV A, P27
- B. MOV A, #27H
- C. MOV A, 27H
- D. MOV A, @27 Discuss
- 6. This program code will read data from port 0 and write it to port 2, and it will stop looping when bit 3 of port 2 is set:
STAT: MOV A, PO MOV P2,A JNB P2.3, STAT
Options- A. True
- B. False Discuss
- 7. The 8051 can handle ________ interrupt sources.
Options- A. 3
- B. 4
- C. 5
- D. 6 Discuss
- 8. The 8-bit address bus allows access to an address range of:
Options- A. 0000 to FFFFH
- B. 000 to FFFH
- C. 00 to FFH
- D. 0 to FH Discuss
- 9. Which of the following commands will copy the contents of location 4H to the accumulator?
Options- A. MOV A, 04H
- B. MOV A, L4
- C. MOV L4, A
- D. MOV 04H, A Discuss
- 10. The following command will rotate the 8 bits of the accumulator one position to the left:
RL A
Options- A. True
- B. False Discuss
The 8051 Microcontroller problems
Search Results
Correct Answer: True
Correct Answer: True
Correct Answer: 20H through 2FH
Correct Answer: True
Correct Answer: MOV A, #27H
Correct Answer: True
Correct Answer: 5
Explanation:
There are five interrupt sources for the 8051, which means that they can recognize 5 different events that can interrupt regular program execution. Each interrupt can be enabled or disabled by setting bits of the IE register. Likewise, the whole interrupt system can be disabled by clearing the EA bit of the same register.
Correct Answer: 00 to FFH
Correct Answer: MOV A, 04H
Correct Answer: True
Comments
More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.
nice