Discussion
Home ‣ Digital Electronics ‣ Multivibrators and 555 Timer Comments
- Question
When a capacitor charges:
Options- A. the voltage across the plates rises exponentially
- B. the circuit current falls exponentially
- C. the capacitor charges to the source voltage in 5×RC seconds
- D. all of the above
- Correct Answer
- all of the above
- 1. The output of the astable circuit ________.
Options- A. constantly switches between two states
- B. is LOW until a trigger is received
- C. is HIGH until a trigger is received
- D. floats until triggered Discuss
- 2. With most monostable multivibrators, what is the Q output when no input trigger has occurred?
Options- A. LOW
- B. +5 V
- C. SET
- D. HIGH Discuss
- 3. Which of the following is NOT a characteristic of a retriggerable monostable multivibrator?
Options- A. It is a dual multivibrator.
- B. It has an active-HIGH reset, which terminates all timing functions.
- C. It has no internal timing resistor.
- D. none of the above Discuss
- 4. What is the difference between a retriggerable one shot and a nonretriggerable one shot?
Options- A. The nonretriggerable can only be triggered once.
- B. The retriggerable can be triggered many times.
- C. The output pulse can be stretched with a nonretriggerable.
- D. The output pulse can be stretched with a retriggerable. Discuss
- 5. Pulse stretching, time-delay, and pulse generation are all easily accomplished with which type of multivibrator circuit?
Options- A. astable
- B. monostable
- C. multistable
- D. bistable Discuss
- 6. The pulse width out of a one-shot multivibrator increases when the:
Options- A. supply voltage increases
- B. timing resistor decreases
- C. UTP decreases
- D. timing capacitance increases Discuss
- 7. What is another name for a bistable multivibrator?
Options- A. an on-off switch
- B. an oscillator
- C. a flip-flop Discuss
- 8. A 0.3-µF capacitor has an initial charge of 2.7 V. If it is discharged through a 10-kΩ resistor for 6.5 ms, how much voltage will be left across the capacitor?
Options- A. 0.0 V
- B. 0.309 V
- C. 2.7 V
- D. 2.295 V Discuss
- 9. This program code will be executed once:
STAT: MOV A, #01H JNZ STAT
Options- A. True
- B. False Discuss
- 10. The following program will cause the 8051 to be stuck in a loop:
LOOP: MOV A, #00H JNZ LOOP
Options- A. True
- B. False Discuss
Multivibrators and 555 Timer problems
Search Results
Correct Answer: constantly switches between two states
Correct Answer: LOW
Correct Answer: It has an active-HIGH reset, which terminates all timing functions.
Correct Answer: The output pulse can be stretched with a retriggerable.
Correct Answer: monostable
Correct Answer: supply voltage increases
Correct Answer: a flip-flop
Correct Answer: 0.309 V
Correct Answer: False
Correct Answer: False
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.