logo

CuriousTab

CuriousTab

Discussion


Home Digital Electronics Integrated Circuit Technologies Comments

  • Question
  • Which is not a MOSFET terminal?


  • Options
  • A. Gate
  • B. Drain
  • C. Source
  • D. Base

  • Correct Answer
  • Base 


  • Integrated Circuit Technologies problems


    Search Results


    • 1. Which transistor element is used in CMOS logic?

    • Options
    • A. FET
    • B. MOSFET
    • C. Bipolar
    • D. Unijunction
    • Discuss
    • 2. Which is not part of emitter-coupled logic (ECL)?

    • Options
    • A. Differential amplifier
    • B. Bias circuit
    • C. Emitter-follower circuit
    • D. Totem-pole circuit
    • Discuss
    • 3. Which logic family combines the advantages of CMOS and TTL?

    • Options
    • A. BiCMOS
    • B. TTL/CMOS
    • C. ECL
    • D. TTL/MOS
    • Discuss
    • 4. Most TTL logic used today is some form of ________.

    • Options
    • A. Schottky TTL
    • B. tristate TTL
    • C. low-power TTL
    • D. open-collector TTL
    • Discuss
    • 5. The greater the propagation delay, the ________.

    • Options
    • A. lower the maximum frequency
    • B. higher the maximum frequency
    • C. maximum frequency is unaffected
    • D. minimum frequency is unaffected
    • Discuss
    • 6. Which equation is correct?

    • Options
    • A. VNL = VIL(max) + VOL(max)
    • B. VNH = VOH(min) + VIH(min)
    • C. VNL = VOH(min) ? VIH(min)
    • D. VNH = VOH(min) ? VIH(min)
    • Discuss
    • 7. A standard TTL circuit with a totem-pole output can sink, in the LOW state (IOL(max)), ________.

    • Options
    • A. 16 mA
    • B. 20 mA
    • C. 16 µA
    • D. 20 µA
    • Discuss
    • 8. It is best not to leave unused TTL inputs unconnected (open) because of TTL's ________.

    • Options
    • A. noise sensitivity
    • B. low-current requirement
    • C. open-collector outputs
    • D. tristate construction
    • Discuss
    • 9. For a CMOS gate, which is the best speed-power product?

    • Options
    • A. 1.4 pJ
    • B. 1.6 pJ
    • C. 2.4 pJ
    • D. 3.3 pJ
    • Discuss
    • 10. An open-collector output requires ________.

    • Options
    • A. a pull-down resistor
    • B. a pull-up resistor
    • C. no output resistor
    • D. an output resistor
    • Discuss


    Comments

    There are no comments.

Enter a new Comment