How many different voltages can be output from a DAC with a 6-bit resolution? 6

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Digital Electronics ‣ Interfacing to the Analog World Comments

Question
How many different voltages can be output from a DAC with a 6-bit resolution?
Options
A. 6
B. 16
C. 32
D. 64

Correct Answer

64

Interfacing to the Analog World problems

Search Results

1. Referring to the given figure, what appears to be wrong, if anything, with the output of the D/A converter?
Options
A. The input signal is probably noisy.
B. There appears to be some nonlinearity in the scope display.
C. The converter has a nonmonotonic output error.
D. It appears that certain input codes are incorrect; double-check the input coding.

2. Referring to the given figure, what should the display on the scope look like if the A/D converter is working properly?
Options
A. It should be a circular Lissajous pattern resulting from the simultaneous application of ramps to the vertical and horizontal inputs of the oscilloscope.
B. The pattern should be a straight line across the screen due to the equal but opposite voltages being applied to the scope inputs.
C. A uniform stairstep pattern should be displayed.
D. The scope should display a sequential binary count with the LSB on the left and the MSB on the right side of the display.

3. What is the resolution of a D/A converter?
Options
A. It is the reciprocal of the number of discrete steps in the D/A output.
B. It is the comparison between the actual output of the converter and its expected output.
C. It is the deviation between the ideal straight-line output and the actual output of the converter.
D. It is the converter's ability to resolve between forward and reverse steps when sequenced over its entire range of inputs.

4. Three characteristics of op amps make them almost ideal amplifiers: very high input impedance, very low impedance, and ________.
Options
A. very high voltage gain
B. unlimited bandwidth
C. a low slew rate
D. very high current gain

5. Which of the equations below expresses the voltage gain relationship for an operational amplifier?
Options
A. V_out = V_in/A_v
B. V_out/V_in = R_out/R_in
C. V_in/V_out = R_out/R_in
D. V_out/V_in = ?R_f/R_in

8. What is the resolution of a D/A converter?
Options
A. the comparison between the actual output of the converter and its expected output
B. the reciprocal of the number of discrete steps in the D/A output
C. the deviation between the ideal straight-line output and the actual output of the converter
D. the ability to resolve between forward and reverse steps when sequenced over its entire range

9. What is the current in R₁ and the current in R₂ for the circuit shown below?
Options
A. I₁ = 0.416 mA, I₂ = 0.416 mA
B. I₁ = 0.357 mA, I₂ = 0.357 mA
C. I₁ = 1.25 mA, I₂ = 0.625 mA
D. I₁ = 0.625 mA, I₂ = 1.25 mA

10. An actuator is usually a device that:
Options
A. converts analog data to meaningful digital data.
B. controls a physical variable.
C. stores digital data and then processes that data according to a set of specified instructions.
D. converts a physical variable to an electrical variable.

Comments

More in Digital Electronics: