What is one advantage to using a parallel-encoded (flash) ADC? less expensive ve

CuriousTab

Home Aptitude

Correct Answer

very fast conversion

2. A test system using the GPIB is being used to monitor a potentially dangerous crash test from a distance of 200 feet. The engineer decides to have you fabricate a special cable, rather than order one, since all the materials are on hand and the tests are already behind schedule. When the tests are run, the test system is erratic and the data is almost useless. What has gone wrong?
Options
A. The engineer is probably not using the correct data format for the specific instruments being used to collect the data.
B. The GPIB cable is too long; a bus extender should be used.
C. The cable should be shielded and properly grounded.
D. The tests themselves probably produced extraneous signals that confused the instruments, resulting in unusable data.

5. The basic approach to testing D/A converters is to:
Options
A. apply a sequence of binary codes covering the full range of input values to the circuit input while observing the output on an oscilloscope. The output should consist of a linear stairstep ramp.
B. single-step the device through its full input range while checking the output with a DMM.
C. check the output with zero input and then full input. The output of the converter should extend from zero to its maximum value. If so, then everything in between can be assumed to be operating properly.
D. apply the correct input to the analog terminal and then check to see if the proper binary code exists on the digital inputs.

7. Which of the equations below expresses the voltage gain relationship for an operational amplifier?
Options
A. V_out = V_in/A_v
B. V_out/V_in = R_out/R_in
C. V_in/V_out = R_out/R_in
D. V_out/V_in = ?R_f/R_in

8. Three characteristics of op amps make them almost ideal amplifiers: very high input impedance, very low impedance, and ________.
Options
A. very high voltage gain
B. unlimited bandwidth
C. a low slew rate
D. very high current gain

9. What is the resolution of a D/A converter?
Options
A. It is the reciprocal of the number of discrete steps in the D/A output.
B. It is the comparison between the actual output of the converter and its expected output.
C. It is the deviation between the ideal straight-line output and the actual output of the converter.
D. It is the converter's ability to resolve between forward and reverse steps when sequenced over its entire range of inputs.

10. Referring to the given figure, what should the display on the scope look like if the A/D converter is working properly?
Options
A. It should be a circular Lissajous pattern resulting from the simultaneous application of ramps to the vertical and horizontal inputs of the oscilloscope.
B. The pattern should be a straight line across the screen due to the equal but opposite voltages being applied to the scope inputs.
C. A uniform stairstep pattern should be displayed.
D. The scope should display a sequential binary count with the LSB on the left and the MSB on the right side of the display.

Comments