Discussion
Home ‣ Digital Electronics ‣ Memory and Storage Comments
- Question
Why do most dynamic RAMs use a multiplexed address bus?
Options- A. It is the only way to do it.
- B. to make it faster
- C. to keep the number of pins on the chip to a minimum
- Correct Answer
- to keep the number of pins on the chip to a minimum
- 1. The mask ROM is ________.
Options- A. permanently programmed during the manufacturing process
- B. volatile
- C. easy to reprogram
- D. extremely expensive Discuss
- 2. CCD stands for ________.
Options- A. capacitor charging device
- B. capacitor-capacitor drain
- C. charged-capacitor device
- D. charge-coupled device Discuss
- 3. The reason the data outputs of most ROM ICs are tristate outputs is to:
Options- A. allow for three separate data input lines.
- B. allow the bidirectional flow of data between the bus lines and the ROM registers.
- C. permit the connection of many ROM chips to a common data bus.
- D. isolate the registers from the data bus during read operations. Discuss
- 4. Suppose that a certain semiconductor memory chip has a capacity of 8K × 8. How many bytes could be stored in this device?
Options- A. 8,000
- B. 64,000
- C. 65,536
- D. 8,192 Discuss
- 5. Typically, how often is DRAM refreshed?
Options- A. 2 to 8 ms
- B. 4 to 16 ms
- C. 8 to 16 µs
- D. 1 to 2 µs Discuss
- 6. What is the major difference between SRAM and DRAM?
Options- A. DRAMs must be periodically refreshed.
- B. SRAMs can hold data via a static charge, even with power off.
- C. The only difference is the terminal from which the data is removed?from the FET Drain or Source.
- D. Dynamic RAMs are always active; static RAMs must reset between data read/write cycles. Discuss
- 7. Data is written to and read from the disk via a magnetic ________ head mechanism in the floppy drive.
Options- A. cylinder
- B. read/write
- C. recordable
- D. cluster Discuss
- 8. On a CD-ROM, ________ are raised areas representing a 1.
Options- A. mounds
- B. lands
- C. holes
- D. pits Discuss
- 9. The location of a unit of data in a memory array is called its ________.
Options- A. storage
- B. RAM
- C. address
- D. data Discuss
- 10. For the given circuit, what memory location is being addressed?
Options- A. 10111
- B. 249
- C. 5
- D. 157 Discuss
Memory and Storage problems
Search Results
Correct Answer: permanently programmed during the manufacturing process
Correct Answer: charge-coupled device
Correct Answer: permit the connection of many ROM chips to a common data bus.
Correct Answer: 8,192
Correct Answer: 4 to 16 ms
Correct Answer: DRAMs must be periodically refreshed.
Correct Answer: read/write
Correct Answer: lands
Correct Answer: address
Correct Answer: 249
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.