Discussion
Home ‣ Digital Electronics ‣ Shift Registers Comments
- Question
Another way to connect devices to a shared data bus is to use a ________.
Options- A. circulating gate
- B. transceiver
- C. bidirectional encoder
- D. strobed latch
- Correct Answer
- transceiver
- 1. When an 8-bit serial in/serial out shift register is used for a 20 µs time delay, the clock frequency is ________.
Options- A. 40 kHz
- B. 50 kHz
- C. 400 kHz
- D. 500 kHz Discuss
- 2. A sequence of equally spaced timing pulses may be easily generated by which type of counter circuit?
Options- A. ring shift
- B. clock
- C. Johnson
- D. binary Discuss
- 3. An 8-bit serial in/serial out shift register is used with a clock frequency of 150 kHz. What is the time delay between the serial input and the Q3 output?
Options- A. 1.67 µs
- B. 26.67 µs
- C. 26.7 ms
- D. 267 ms Discuss
- 4. In a parallel in/parallel out shift register, D0 = 1, D1 = 1, D2 = 1, and D3 = 0. After three clock pulses, the data outputs are ________.
Options- A. 1110
- B. 0001
- C. 1100
- D. 1000 Discuss
- 5. What is a transceiver circuit?
Options- A. a buffer that transfers data from input to output
- B. a buffer that transfers data from output to input
- C. a buffer that can operate in both directions Discuss
- 6. A 74HC195 4-bit parallel access shift register can be used for ________.
Options- A. serial in/serial out operation
- B. serial in/parallel out operation
- C. parallel in/serial out operation
- D. all of the above Discuss
- 7. The primary purpose of a three-state buffer is usually:
Options- A. to provide isolation between the input device and the data bus
- B. to provide the sink or source current required by any device connected to its output without loading down the output device
- C. temporary data storage
- D. to control data flow Discuss
- 8. In a 4-bit Johnson counter sequence there are a total of how many states, or bit patterns?
Options- A. 1
- B. 2
- C. 4
- D. 8 Discuss
- 9. Computers operate on data internally in a ________ format.
Options- A. tristate
- B. universal
- C. parallel
- D. serial Discuss
- 10. Which is not characteristic of a shift register?
Options- A. Serial in/parallel in
- B. Serial in/parallel out
- C. Parallel in/serial out
- D. Parallel in/parallel out Discuss
Shift Registers problems
Search Results
Correct Answer: 400 kHz
Correct Answer: ring shift
Correct Answer: 26.67 µs
Correct Answer: 0001
Correct Answer: a buffer that can operate in both directions
Correct Answer: all of the above
Correct Answer: to provide isolation between the input device and the data bus
Correct Answer: 8
Correct Answer: parallel
Correct Answer: Serial in/parallel in
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.