logo

CuriousTab

CuriousTab

Discussion

Home ‣ Digital Electronics ‣ Signals and Switches Comments
  • Question

  • Is the transistor in the given figure considered ON or OFF?

    Is the transistor in the given figure considered ON or OFF? OFF ON Not enough information is provide


  • Options
  • A. OFF
  • B. ON
  • C. Not enough information is provided.

  • Correct Answer
  • OFF 

    • Signals and Switches problems

    Search Results

    • 1. The hexadecimal number 4B16 is transmitted as an 8-bit word in parallel. What is the time required for this transmission if the clock frequency is 2.25 MHz?

    • Options
    • A. 444 ns
    • B. 444 µs
    • C. 3.55 µs
    • D. 3.55 ms
      • Discuss
    • 2. What is the advantage of using serial data transmission over parallel data transmission?

    • Options
    • A. It is slower.
    • B. Only one pair of wires is required.
    • C. More people use it.
    • D. It is faster.
      • Discuss
    • 3. If the input voltage on D1 in the given figure is changed to 0 V, what is the output voltage Vout?


    • Options
    • A. ?5 V
    • B. 0 V
    • C. +5 V
    • D. +4.3 V
      • Discuss
    • 4. What can a relay provide between the triggering source and the output that semiconductor switching devices cannot?

    • Options
    • A. total isolation
    • B. faster
    • C. higher current rating
    • D. total isolation and higher current rating
      • Discuss
    • 5. What is the frequency of a clock waveform if the period of that waveform is
      1.25 µs?

    • Options
    • A. 8 kHz
    • B. 0.8 kHz
    • C. 0.8 MHz
    • D. 8 MHz
      • Discuss
    • 6. The serial format for transmitting binary information uses:

    • Options
    • A. a single conductor
    • B. multiple conductors
    • C. infrared technology
    • D. fiber-optic
      • Discuss
    • 7. Determine the output voltage Vout for the circuit in the given figure.


    • Options
    • A. ?0.5 V
    • B. 0 V
    • C. +5 V
    • D. +4.3 V
      • Discuss
    • 8. To forward bias a diode, a ________ potential is needed on the ________ and a ________ is needed on the ________.

    • Options
    • A. negative, cathode, positive, anode
    • B. negative, anode, positive, cathode
      • Discuss
    • 9. The units for the HIGH time for a periodic wave are ________.

    • Options
    • A. seconds
    • B. hertz
    • C. cycles
    • D. %
      • Discuss
    • 10. What logic function is the sum output of a half-adder?

    • Options
    • A. AND
    • B. exclusive-OR
    • C. exclusive-NOR
    • D. NAND
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.