logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Resistance and Power Comments
  • Question

  • The source is 24 volts and the load resistance is 100 Ω. What is the load current?


  • Options
  • A. 2.4 A
  • B. 240 mA
  • C. 24 mA
  • D. 2.4 mA

  • Correct Answer
  • 240 mA 

    • Resistance and Power problems

    Search Results

    • 1. Power is measured in units of:

    • Options
    • A. joules x charge
    • B. joules/work
    • C. joules x voltage
    • D. joules/time
      • Discuss
    • 2. Resistance in a circuit is:

    • Options
    • A. opposition to current
    • B. opposition to voltage
    • C. the same as current
    • D. the same as voltage
      • Discuss
    • 3. What value of a 1.3 kΩ resistor as measured by a digital voltmeter would be considered within tolerance?

    • Options
    • A. 1234 Ω
    • B. 1235 Ω
    • C. 1366 Ω
    • D. 1367 Ω
      • Discuss
    • 4. Resistance is:

    • Options
    • A. the opposition to current flow accompanied by the dissipation of heat
    • B. symbolized by R, measured in ohms, and directly proportional to conductance
    • C. directly proportional to current and voltage
    • D. represented by the flow of fluid in the fluid circuit
      • Discuss
    • 5. What are the two major categories for resistors?

    • Options
    • A. low and high ohmic value
    • B. commercial and industrial
    • C. low and high power value
    • D. fixed and variable
      • Discuss
    • 6. Which type of test equipment is used to measure resistors?

    • Options
    • A. ohmmeter
    • B. ammeter
    • C. voltmeter
    • D. watt meter
      • Discuss
    • 7. How is a 3.9 kΩ resistor color-coded?

    • Options
    • A. red, white, red, gold
    • B. red, green, orange, silver
    • C. orange, white, red, gold
    • D. orange, green, orange, silver
      • Discuss
    • 8. How much energy is stored if 6.24 x 1018 electrons are stored in 4 volts?

    • Options
    • A. 4 joules
    • B. 1.56 x 1018 electrons
    • C. 1.56 coulombs
    • D. 2.496 x 1019 electrons
      • Discuss
    • 9. The unit designator for resistance value is the:

    • Options
    • A. ampere
    • B. ohm
    • C. volt
    • D. watt
      • Discuss
    • 10. Which is the most important step utilized when measuring resistors?

    • Options
    • A. use the highest possible scale
    • B. keep test leads short
    • C. zero the meter before using
    • D. remove power from the circuit
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.