logo

CuriousTab

CuriousTab

Transformers problems

  • 1. Electronics Transformers: What is the cur

    What is the current through the load in the given circuit?


  • Options
  • A. 500 µA
  • B. 10 mA
  • C. 250 mA
  • D. 1.25 A
    • Discuss
  • 2. A transformer has

  • Options
  • A. primary and secondary windings, both of which are considered inputs
  • B. primary and secondary windings, both of which are considered outputs
  • C. a primary winding used as an output and a secondary winding used as an input
  • D. a primary winding used as an input and a secondary winding used as an output
    • Discuss
  • 3. Increasing the number of turns of wire on the secondary of a transformer will

  • Options
  • A. increase the secondary current
  • B. decrease the secondary current
  • C. have no effect on the secondary current
  • D. increase the primary current
    • Discuss
  • 4. The coefficient of coupling between two coils is 0.45. The first coil has an inductance of 75 mH and the second coil has an inductance of 105 mH. What is the mutual inductance between the coils?

  • Options
  • A. 3.54 mH
  • B. 7.88 mH
  • C. 39.9 mH
  • D. 189.3 mH
    • Discuss
  • 5. What is the turns ratio of the transformer needed to match a 1 kΩ source resistance to a 160 Ω load?

  • Options
  • A. 2.5:1
  • B. 0.4:1
  • C. 6.25:1
  • D. 16:1
    • Discuss
  • 6. Electronics Transformers: If the load dou

    If the load doubled in value in the given circuit, what reflected resistance would the source see?


  • Options
  • A. 80 Ω
  • B. 400 Ω
  • C. 2 kΩ
  • D. 10 kΩ
    • Discuss
  • 7. Mutual induction is dependent on

  • Options
  • A. winding ratios
  • B. output polarities
  • C. dc voltage levels
  • D. current changes
    • Discuss
  • 8. Electronics Transformers: What is the pow

    What is the power dissipated in the primary of the transformer in the given circuit?


  • Options
  • A. 25 mW
  • B. 500 mW
  • C. 12.5 W
  • D. 62.5 W
    • Discuss
  • 9. A special transformer used to convert unbalanced signals to balanced signals is the

  • Options
  • A. balun
  • B. autotransformer
  • C. center-tapped transformer
  • D. step-across transformer
    • Discuss
  • 10. Electronics Transformers: What is the sec

    What is the secondary voltage in the given circuit?


  • Options
  • A. 13.3 V rms in phase with the primary
  • B. 120 V rms in phase with the primary
  • C. 13.3 V rms out of phase with the primary
  • D. 120 V rms out of phase with the primary
    • Discuss

First 2 3 4

Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.