logo

CuriousTab

CuriousTab

Discussion


Home Biochemical Engineering Water Treatment Comments

  • Question
  • Which of the following chemical is sometime added in the process of coagulation and flocculation?


  • Options
  • A. Aluminum sulphate
  • B. Aluminum oxide
  • C. Calcium chloride
  • D. None of these

  • Correct Answer
  • Aluminum sulphate 


  • Water Treatment problems


    Search Results


    • 1. Biological oxidation processes usually referred as biological treatment, are the most common form of

    • Options
    • A. primary treatment
    • B. secondary treatment
    • C. tertiary treatment
    • D. all of these
    • Discuss
    • 2. Sedimentation is a physical process used in wastewater treatment to

    • Options
    • A. remove particles that are less dense than water
    • B. remove particles that are more dense than water
    • C. remove the pertinacious material from the water
    • D. none of the above
    • Discuss
    • 3. Permanent hard water may be softened by passing it through

    • Options
    • A. sodium silicate
    • B. sodium bicarbonate
    • C. sodium hexametaphosphate
    • D. sodium phosphate
    • Discuss
    • 4. Hardness of water does not

    • Options
    • A. have any bad effect in boiler
    • B. make cooking of foods difficult
    • C. make it unfit for drinking
    • D. cause difficulty in the washing of clothes with soaps
    • Discuss
    • 5. The chemical oxygen demand (COD)measures the

    • Options
    • A. amount of oxygen required for growth of microorganisms in water
    • B. amount of oxygen that would be removed from the water in order to oxidize pollution
    • C. amount of oxygen required to oxidize the calcium present in waste water
    • D. none of the above
    • Discuss
    • 6. Zeolite softening process removes

    • Options
    • A. only temporary hardness of water
    • B. only permanent hardness of water
    • C. both temporary and permanent hardness of water
    • D. the dissolved gases in permanent hard water
    • Discuss
    • 7. The water being used in dairy industry should contain not more than

    • Options
    • A. 5 proteolytic and/or lipolytic organisms per ml
    • B. 10 proteolytic and/or lipolytic organisms per ml
    • C. 15 proteolytic and/or lipolytic organisms per ml
    • D. 20 proteolytic and/or lipolytic organisms/ml
    • Discuss
    • 8. Both temporary and permanent hardness of water can be removed on boiling water with

    • Options
    • A. calcium hydroxide
    • B. sodium carbonate
    • C. calcium oxide
    • D. calcium carbonate
    • Discuss
    • 9. Conventional tertiary treatment is

    • Options
    • A. chemical coagulation and flocculation
    • B. filtration
    • C. sedimentation
    • D. none of these
    • Discuss
    • 10. According to BIS the maximum permissible limit of dissolved solids in drinking water is

    • Options
    • A. 1000 mg/l
    • B. 500 mg/l
    • C. 2000 mg/l
    • D. 1500 mg/l
    • Discuss


    Comments

    There are no comments.

Enter a new Comment