logo

CuriousTab

CuriousTab

Discussion


Home Biochemical Engineering Agitation and Aeration Comments

  • Question
  • Which of the following(s) is/are non-mechanically agitated reactors?


  • Options
  • A. Stirrer tank reactor
  • B. Bubble column
  • C. Air lift reactor
  • D. Both (b) and (c)

  • Correct Answer
  • Both (b) and (c) 


  • Agitation and Aeration problems


    Search Results


    • 1. The range of width for the baffle in the fermenter is __________ times of vessel diameter

    • Options
    • A. 1/10 to 1/12
    • B. 1/8 to 1/10
    • C. 1/5 to 1/8
    • D. none of these
    • Discuss
    • 2. Why vortexing is undesirable in the agitation of biological systems?

    • Options
    • A. The collision between the cells, impeller and air bubbles will lead to cell damage
    • B. Poor mixing despite the use of high stirrer speeds
    • C. Mixing will not be in the turbulent region
    • D. All of the above
    • Discuss
    • 3. The reason of using a flat disk in a Turbine is

    • Options
    • A. to create high shear conditions
    • B. to break up bubbles more efficiently than the impeller blades
    • C. to ensure that the bulk of the energy consumption occurs at the blades
    • D. all of the above
    • Discuss
    • 4. Power consumption by agitation is

    • Options
    • A. a function of physical properties
    • B. a function of operating conditions
    • C. a function of vessel and impeller geometry
    • D. all of the above
    • Discuss
    • 5. Power number is ratio of

    • Options
    • A. imposed forced to intertial force
    • B. bouyant force to inertial force
    • C. gravitation force to inertial force
    • D. imposed force to gravitational force
    • Discuss
    • 6. An aerated bioreactor will increase oxygen transfer rates with the addition of detergents because it

    • Options
    • A. enhances bubble coalescence
    • B. causes bubbles to expand
    • C. discourages bubble coalescence
    • D. increases the surface tension of the liquid
    • Discuss
    • 7. The average fractional gas hold up (H) can be given as (where Zf and Zl are the level of aerated and clear liquid respectively)

    • Options
    • A. H = (Zf-Zl)/Zf
    • B. H = Zf/Zl
    • C. H = Zf/ZfZl
    • D. H =(Zf+Zl)/Zf
    • Discuss
    • 8. Vortexing in stirred tank reactors can be prevented by

    • Options
    • A. installing baffles in the reactor
    • B. shifting the impeller to an off-centre position
    • C. Both (a) and (b)
    • D. using axial flow impellers
    • Discuss
    • 9. A typical ceiling fan would be best described as a(n)

    • Options
    • A. radial flow impeller
    • B. axial flow impeller
    • C. intermig impeller
    • D. Rushton turbine
    • Discuss
    • 10. Which of the following is not considered among the three best-known theories of interphase mass transfer?

    • Options
    • A. two-film theory
    • B. penetration theory
    • C. surface renewal theory
    • D. Calderbank and Moo-Young theory
    • Discuss


    Comments

    There are no comments.

Enter a new Comment