logo

CuriousTab

CuriousTab

Discussion


Home Biochemical Engineering Agitation and Aeration Comments

  • Question
  • Power number is ratio of


  • Options
  • A. imposed forced to intertial force
  • B. bouyant force to inertial force
  • C. gravitation force to inertial force
  • D. imposed force to gravitational force

  • Correct Answer
  • imposed forced to intertial force 


  • Agitation and Aeration problems


    Search Results


    • 1. What is the ratio of depth of liquid in vessel to the diameter of tank (H:Dt)?

    • Options
    • A. 1 : 1
    • B. 2 : 1
    • C. 4 : 1
    • D. none of these
    • Discuss
    • 2. Which of the following best explains the reasons for using axial flow impellers in crystallization and precipitation reactions?

    • Options
    • A. Crystal and precipitates are not too small, so as to ensure easy separation of the solids from the mother liquor
    • B. Crystals and precipitates are thoroughly broken down, so as to ensure easy separation of the solids from the mother liquor
    • C. Both (a) and (b)
    • D. Axial flow impellers provide low shear, energy efficient mixing conditions
    • Discuss
    • 3. The average concentration of oxygen in the boundary layers surrounding the bubbles (Co*) in a reactor is normally determined by

    • Options
    • A. ultra-small dissolved oxygen probes
    • B. laser based photographic systems
    • C. measuring the steady state concentration of oxygen in the bulk liquid prior to inoculation of the reactor
    • D. measuring the steady state concentration of oxygen in the bulk liquid after inoculation of the reactor
    • Discuss
    • 4. Which of the following impellers will provide radial flow?

    • Options
    • A. Paddles
    • B. Flat blade turbines
    • C. Disk flat blade turbines
    • D. All of the above
    • Discuss
    • 5. Power number is expressed as

    • Options
    • A. P0 / N2Di3?
    • B. P0 / N3Di5?
    • C. P0 / N3Di3?
    • D. P0 / N2Di2?
    • Discuss
    • 6. Power consumption by agitation is

    • Options
    • A. a function of physical properties
    • B. a function of operating conditions
    • C. a function of vessel and impeller geometry
    • D. all of the above
    • Discuss
    • 7. The reason of using a flat disk in a Turbine is

    • Options
    • A. to create high shear conditions
    • B. to break up bubbles more efficiently than the impeller blades
    • C. to ensure that the bulk of the energy consumption occurs at the blades
    • D. all of the above
    • Discuss
    • 8. Why vortexing is undesirable in the agitation of biological systems?

    • Options
    • A. The collision between the cells, impeller and air bubbles will lead to cell damage
    • B. Poor mixing despite the use of high stirrer speeds
    • C. Mixing will not be in the turbulent region
    • D. All of the above
    • Discuss
    • 9. The range of width for the baffle in the fermenter is __________ times of vessel diameter

    • Options
    • A. 1/10 to 1/12
    • B. 1/8 to 1/10
    • C. 1/5 to 1/8
    • D. none of these
    • Discuss
    • 10. Which of the following(s) is/are non-mechanically agitated reactors?

    • Options
    • A. Stirrer tank reactor
    • B. Bubble column
    • C. Air lift reactor
    • D. Both (b) and (c)
    • Discuss


    Comments

    There are no comments.

Enter a new Comment