logo

CuriousTab

CuriousTab

Discussion


Home Biochemical Engineering Fermentation Kinetics Comments

  • Question
  • Heat transfer rates (per unit volume) will be lowest in


  • Options
  • A. Stirred tank bioreactor with biomass recycle
  • B. Continuous air lift bioreactor
  • C. Continuous packed bed reactor
  • D. Continuous fluidized bed bioreactor

  • Correct Answer
  • Continuous packed bed reactor 


  • Fermentation Kinetics problems


    Search Results


    • 1. Which of the following is correct for the prediction of time requirement in a batch fermenter?

    • Options
    • A. Carrying out experiments
    • B. Mathematical modelling of the fermentation process
    • C. Both (a) and (b)
    • D. It is impossible to predict the time required for fermentation
    • Discuss
    • 2. Stationary phase is described as

    • Options
    • A. no further increase in the cell population after a maximum value
    • B. deceleration of growth and division rate after the growth rate reaches a maximum
    • C. acceleration of growth and division rate after the growth rate reaches a maximum
    • D. deceleration of growth and division rate after the growth rate reaches a minimum
    • Discuss
    • 3. The high oxygen transfer efficiencies of airlift bioreactors is due to

    • Options
    • A. the large aspect ratio of the reactor, which leads to a high gas hold-up
    • B. the large aspect ratio of the reactor, which leads to a high oxygen solubility at the base of the reactor
    • C. the draft tube, which reduces bubble coalescence in the reactor
    • D. all of the above
    • Discuss
    • 4. A higher Ks value of Monod's equation means

    • Options
    • A. greater affinities to substrate
    • B. lower affinities to substrate
    • C. unaffected with the substrate bonding
    • D. lower dissociation constant value
    • Discuss
    • 5. The maximum specific growth rate of an organism depends on

    • Options
    • A. medium composition
    • B. temperature
    • C. pH
    • D. All of these
    • Discuss
    • 6. The number of baffles in a standard stirred tank bioreactor is

    • Options
    • A. 8
    • B. 6
    • C. 4
    • D. 2
    • Discuss
    • 7. Bacterial growth curve is obtained by plotting

    • Options
    • A. number of cells versus time
    • B. number fo spores versus time
    • C. log of number of cells versus time
    • D. log of number of cells survived versus time
    • Discuss
    • 8. The contents in jet loop reactor are mixed through

    • Options
    • A. compressed air
    • B. a mechanical agitator
    • C. external pumping
    • D. any of these
    • Discuss
    • 9. Why a T-flask used in small-scale cell culture is incubated in a horizontal position?

    • Options
    • A. To save space
    • B. To increase the surface area of the liquid-air interface
    • C. Both (a) and (b)
    • D. To increase the rate of oxygen transfer into the liquid
    • Discuss
    • 10. Wash out in steady state fermentation occurs when

    • Options
    • A. dilution rate is less than maximum specific growth rate
    • B. dilution rate is higher than the maximum specific growth rate
    • C. cell concentration reaches the maximum
    • D. specific growth rate is maximum
    • Discuss


    Comments

    There are no comments.

Enter a new Comment