Induction wattmeter can be used in ac circuit only dc circuit only both ac and d

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Measurements and Instrumentation Comments

Correct Answer

ac circuit only

Explanation

Induction effect occurs with ac only.

Measurements and Instrumentation problems

Search Results

2. In two wattmeter method of 3 phase power measurement, when does one wattmeter read negative
Options
A. when power factor is less than 0.5 lagging
B. when power factor is greater than 0.5 lagging
C. when power factor is less than 0.5
D. when power factor is unity

3. An LVDT is used to measure displacement. The LVDT feeds a Voltmeter of 0-5 V range through a 250 gain amplifier. For a displacement 0.5 mm the output of LVDT is 2 mV. The sensitivity of instrument is
Options
A. 0.1 V/mm
B. 0.5 V/mm
C. 1 V/mm
D. 5 V/mm

4. An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
Options
A. 2%
B. 2.5%
C. 4%
D. 5%

5. A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge amplifier and overall gain of transducer and amplifier is 50 mV/N. The gain of amplifier is
Options
A. 1 mV/pC
B. 1.5 mV/pC
C. 2.5 mV/pC
D. 4 mV/pC

6. A standard cell of 1.0185 V is used with a slide wire potentiometer. The balance was obtained at 60 cm. When an unknown emf was connected, the balance was obtained at 82 cm. The magnitude of unknown emf is
Options
A. 1.39 V
B. 0.75 V
C. 13.9 V
D. 7.45 V

7. To increase Q factor of a coil, the wire should be
Options
A. long
B. thin
C. thick
D. long and thin

8. The Lissajous pattern observed on screen of CRO is a straight line inclined at 45� to x axis. If X-plate input is 2 sin ?t, the Y-plate input is
Options
A. 2 sin ?t
B. 2 sin (?t + 45�)
C. 2 sin (?t - 45�)
D. 22 sin ?t + 45�)

9. The angle ? for a mica capacitor is about
Options
A. 25�
B. 15�
C. 5�
D. 1�

10. A voltmeter using thermocouples measures
Options
A. rms value
B. peak value
C. average value
D. peak to peak value

Comments

There are no comments.

More in Electronics and Communication Engineering: