When a tension member is made of four angles with a plate as a web, the allowanc

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Civil Engineering ‣ Steel Structure Design Comments

Question
When a tension member is made of four angles with a plate as a web, the allowance for holes is made as
Options
A. two holes for each angle and one hole for the web
B. one hole for each angle and one hole for the web
C. one hole for each angle and two holes for the web
D. two holes for each angle and two holes for the web
E. none of these.

Correct Answer

one hole for each angle and two holes for the web

Steel Structure Design problems

Search Results

1. The equivalent axial tensile load P_e, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
Options
A.
B.
C.
D.

3. For the steel member exposed to weather and accessible for repainting, the thickness of steel should not be less than (excepting the webs of Indian Standard rolled steel joists and channels).
Options
A. 4 mm
B. 6 mm
C. 8 mm
D. 10 mm

6. The minimum edge distance of a rivet line connecting two or more plates, is kept equal to 37 mm plus (where t is the thickness in mm of the thinner outside plate).
Options
A. 2 t
B. 4 t
C. 6 t
D. 8 t
E. 10 t

7. If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is
Options
A. 6
B. 8
C. 10
D. 12
E. 15

9. The thickness t of a single flat lacing should not be less than
Options
A. 1/30 th length between inner end rivets
B. 1/40 th length between inner end rivets
C. 1/50 th length between inner end rivets
D. 1/60 th length between inner end rivets
E. none of these.

10. Column footing is provided
Options
A. to spread the column load over a larger area
B. to ensure that intensity of bearing pressure between the column footing and soil does not exceed permissible bearing capacity of the soil
C. to distribute the column load over soil through the column footing
D. all the above.

Comments

More in Civil Engineering: