logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Machine Design See What Others Are Saying!
  • Question
  • In unilateral system of tolerance, the tolerance is allowed on


  • Options
  • A. one side of the actual size
  • B. one side of the nominal size
  • C. both sides of the actual size
  • D. both sides of the nominal size

  • Correct Answer
  • one side of the nominal size 


  • More questions

    • 1. The elongation of a conical bar under its own weight is __________ that of prismatic bar of the same length.

    • Options
    • A. equal to
    • B. half
    • C. one-third
    • D. two-third
    • Discuss
    • 2. The liquid used in manometers should have

    • Options
    • A. low density
    • B. high density
    • C. low surface tension
    • D. high surface tension
    • Discuss
    • 3. According to Kelvin-Planck's statement, a perpetual motion of the __________ is impossible.

    • Options
    • A. first kind
    • B. second kind
    • Discuss
    • 4. The unit of power in S.I. units is kilowatt.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. The purpose of transmission in an automobile is

    • Options
    • A. to vary the speed of automobile
    • B. to vary the torque at the wheels
    • C. to vary the power of automobile
    • D. none of these
    • Discuss
    • 6. The shear force of a cantilever beam of length l and carrying a gradually varying load from zero at the free end and w per unit length at the fixed end is __________ at the fixed end.

    • Options
    • A. zero
    • B. wl/4
    • C. wl/2
    • D. wl
    • Discuss
    • 7. The height of each tooth of a broach is

    • Options
    • A. same throughout
    • B. in progressively decreasing order
    • C. in progressively increasing order
    • D. none of these
    • Discuss
    • 8. A feed gear box for a screw cutting lathe is designed on the basis of

    • Options
    • A. geometric progression
    • B. arithmetic progression
    • C. harmonic progression
    • D. none of these
    • Discuss
    • 9. The maximum bending moment of a simply supported beam of span l and carrying a point load W at the centre of beam, is

    • Options
    • A. Wl/4
    • B. Wl/2
    • C. Wl
    • D. Wl2/4
    • Discuss
    • 10. A device used in a boiler to control the flow of steam from the boiler to the main pipe and to shut off the steam completely when required, is known as

    • Options
    • A. blow off cock
    • B. fusible plug
    • C. superheater
    • D. stop valve
    • Discuss


    Comments

    There are no comments.

Enter a new Comment