Discussion
Home ‣ Certification ‣ CISCO Certification Comments
- Question
Convert the following from binary format to hexadecimal 11001010.11110101.10000011.11101011
- Correct Answer
- Answer
- 1. Convert the following from decimal IP address to binary format. 192.168.10.15 Discuss
- 2. Which of the following is correct?
Options- A. Full- duplex Ethernet uses one pair of wires
- B. Full- duplex Ethernet uses two pairs of wires
- C. Half- duplex Ethernet uses two pairs of wires
- D. Full- duplex Ethernet uses three pairs of wires Discuss
- 3. In the operation of CSMA/CD, which host(s) have priority after the expiration of the backoff algorithm?
Options- A. All hosts have equal priority
- B. The two hosts that caused the collision will have equal priority
- C. The host that sent the jam signal after the collision
- D. The host with the highest MAC address Discuss
- 4. What is the specific term for the unwanted signal interference from adjacent pairs in the cable?
Options- A. EMI
- B. RFI
- C. Crosstalk
- D. Attenuation Discuss
- 5. When making a HyperTerminal connection, what must the bit rate be set to?
Options- A. 2400bps
- B. 1200bps
- C. 9600bps
- D. 6400bps Discuss
- 6. A static map to the S-AMER location is required. Which command should be used to create this map? A. frame-relay map ip 172.16.1.3 704 broadcast B. frame-relay map ip 172.16.1.3 196 broadcast C. frame-relay map ip 172.16.1.3 702 broadcast D. frame-relay map ip 172.16.1.3 344 broadcast Discuss
- 7. As a Cisco technician, you need to know EIGRP protocol very well. Which of the following is true about EIGRP successor routes? (Choose two) A. A successor route is used by EIGRP to forward traffic to a destination B. Successor routes are stored in the neighbor table following the discovery process C. Successor routes are flagged as "active" in the routing table D. A successor route may be backed up by a feasible successor route Discuss
- 8. Users on the 192.168.10.0/24 network must access files located on the Server 1. What route could be configured on router R1 for file requests to reach the server? A. IP route 0.0.0.0 0.0.0.0 s0/0/0 B. IP route 0.0.0.0 0.0.0.0 209.165.200.226 C. IP route 209.165.200.0 255.255.255.0 192.168.10.250 D. IP route 192.168.10.0 255.255.255.0 209.165.100.250 Discuss
- 9. All hosts in the networks have been operational for several hours when the DHCP server goes down. What happens to the hosts that have obtained service from the DHCP server? A. The hosts will not be able to communicate with any other hosts. B. The hosts will continue to communicate normally for a period of time. C. The hosts will be able to communicate with hosts outsides their own network D. The hosts will only be able to communicate with other hosts by IP address not by host name Discuss
- 10. What is the purpose of the DHCP server? A - to provide storage for email B - to translate URLs to IP addresses C - to translate IPv4 addresses to MAC addresses D - to provide an IP configuration information to hosts Discuss
CISCO Certification problems
Search Results
Correct Answer: Answer
Correct Answer: Full- duplex Ethernet uses two pairs of wires
Correct Answer: All hosts have equal priority
Explanation:
After the expiration of the backoff algorithm , all hosts have equal priority.
Correct Answer: Crosstalk
Explanation:
The term for the unwanted signal interference from adjacent pairs in the cable is crosstalk
Correct Answer: 9600bps
Explanation:
When making a HyperTerminal connection, the bit rate must be set to 9600bps.
Correct Answer: Answer: B
Correct Answer: : A D Explanation: A and D are correct because successor route is the best and primary route to a remote network A successor route is used by EIGRP to forward traffic to a destination and is stored in the routing table Its backed up by a feasible successor route in case the primary route fails, that is stored in the topology table B is incorrect because neighbor table only contains a list of directly connected EIGRP routers that have an adjacency with this router, it doesn't contain successor routes C is incorrect because successor routes found in the routing table are not flagged as "active?
Correct Answer: : A
Correct Answer: : B Explanation : Dynamic Host configuration Protocol ? DHCP ? assigns an IP address to a client for a limited period of time, this address is then saved in a database When the DHCP Server goes down, that client can still use the allocated IP address for a limited period of time
Correct Answer: : D Explanation:The main purpose of the DHCP server is to provide IP configuration parameters to hosts such as the default gateway, domain name, Domain Name System ? DNS
Comments
There are no comments.Programming
Copyright ©CuriousTab. All rights reserved.