What is the command to copy the startup-config filre to DRAM?

More Questions from CISCO Certification

• A network administrator views the output from the show ip route command. A network that is advertised by both RIP and EIGRP appears in the routing table flagged as an EIGRP route. why is the RIP route to this network not used in the routing table?
• If your routing table has a static, a RIP, and an EIGRP route to the same network, which route will be used to route packets by default?
• There are three possible routes for a router to reach a destination network. The first route is from OSPF with a metric of 782. The second route is from RIPv2 with a metric of 4. The third is from EIGRP with a composite metric of 20514560. Which route will be installed by the router in its routing table?
• What four routed protocols are supported by EIGRP?
• What is the purpose of Spanning Tree Protocol in a switched LAN?
• Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?
• You need to stop DoS attacks in real time and have a log of anyone who has tried to attack your network. What should you do your network?
• How many non- overlapping channels are available with 802.11b?
• Which IEEE committee has been sanctioned by WAP and is called WPA2?
• What device must be on your wired network when running an enterprise EAP solution?

Discussion & Comments